cape square body
Latest activity Postings About
-
-
I want to replace rear drive shaft ujoint got new ujoint with exterior clips is this right ? It looks like factory ujoint -
-
Yes the NP208 cases use ATF.
-
Just did rear seal ended up buying seal puller helped bit time I need to top off trans case do I fill with atf ? That's what seamed to...
-
-
cape square body replied to the thread Installing locking hubs.I called tech support at warn and spoke with Shawn and he said yes remove inner snap ring and washer so all good did not have to take...
-
-
cape square body replied to the thread Installing locking hubs.Also there installed i don't think the warn premium hub will slide back enough with snap ring and washer I'm going to pull one off and...
-
cape square body replied to the thread Installing locking hubs.Yea it 87 silverado
-
I'm installing warn locking hubs my question Is when removing old hubs I need to remove inner snap ring and washer right before the...
-
cape square body replied to the thread Motor mounts.Thank you fitz
-
Need to replace motor mounts with motor in place what do in need to watch out for?do need to un do exhaust when lift motor
-
-
cape square body replied to the thread washer pump not working.well removed module and washer motor works fine guess I will go with out delay for now
-
I'm need help with fuel gauge issue it works on drivers side tank and not the other the previous owner replaced tank and sender it...
-
-
Loading…
-
Loading…
