CalSgt's latest activity
-
CCalSgt reacted to Ricko1966's post in the thread Front driveline angles on a lifted square with
Like.
Yokes need to be in phase,and the pinion shaft and transfer case shaft have to be parallel, you got two things going against you. -
CCalSgt replied to the thread Front driveline angles on a lifted square.Transfer case flange pointed up 6 degrees and pinion snout pointed down 5.5 degrees would be about correct for a standard driveshaft...
-
CCalSgt reacted to chief_shotts's post in the thread Front driveline angles on a lifted square with Like.
its a single cardan on both ends.
-
CPower windows should be run off of a breaker, breaker is hot with key in run position. Did you check the breaker? Was the key on? Window...
-
CStarter sounds just fine. Engine fired and kicked out the bendix right as you let off the key. Not problem there.
-
CCalSgt replied to the thread Rear driveshaft for SM 465.Like @bucket said, it will depend on where the engine sits once installed. What transmission was in the truck before? Also you should...
-
CYou cant really run a bigger amp with those speakers anyway, well the 50s you could crank up a bit but not the fronts. 25W rms is a...
-
CCalSgt replied to the thread retrosound.. is it enough.25W RMS is decent enough for standard 2 way or 3 way speakers… Shop for speakers that are designed for a lower RMS power range that...
-
CAll squarebody windshields are the same size and interchangeable. Aside from tint band on top, the only difference is integrated antenna...
-
CDielectric grease. Its non conductive, and keeps water and everything else out.
-
CNew here, not to squarebody life. Have had many throughout the years. Right now just have a 85 GMC rcsb, stepside, 4x4, sm465, with a...
-
CCalSgt replied to the thread Full 1980 square headlight set up..Yeah, I’m happy… I went to a guy in Reno, NV named Luis Feliz. There was a little pitting and a few minor cracks in them where the screw...
-
CWe carry the grilles but we developed our own tooling by reverse engineering. The GM molds would be too worn if they even exist by now
-
CCalSgt replied to the thread Full 1980 square headlight set up..LOL, I’m all for the Krylon restoration but these had to be “show chrome” status
-
