CalSgt's latest activity
-
CCalSgt replied to the thread Questions for expierienced ultrasonic cleaner users.Also…. When cleaning small parts you can fill a ziplock with the parts and cleaning solution so you don’t have to mix/waste gallons of...
-
CCalSgt replied to the thread Questions for expierienced ultrasonic cleaner users.We used to use 110 volt “stingers” to pre heat the sonic cleaners we had. Heat makes a big difference in the cleaning power on sonic...
-
CAre your hinges maxed out in movement? You can enlarge/slot the holes of the hinges at the fenders. You can also add shims under the...
-
CCalSgt replied to the thread Bed liner paint..For about the same cost in materials and prep you could do a single stage 2K urethane paint job with generic or Summit brand products...
-
CI'd have a local builder build it and install it,that way if there's a problem,it's their problem,not your problem. I would not pay...
-
CCalSgt reacted to Ricko1966's post in the thread ‘83 K5 Wiring diagram V8 vs V6 Firewall Block blue wire for oil psi switch requirement??? See pics with
Like.
Maybe not that year,on V8s but they used that same system on some year v8 trucks. Wire your V8 crate motor like it was the I6 if you are... -
CWhen I did the LS swap on my truck, I wire brushed and painted the front half of frame while the drivetrain was out. I used VHT Chassis...
-
CCalSgt replied to the thread C10 LS Swap Actual Cold Air Intake.Looks really nice, good job
-
CFinished up my LS swap (L76 aluminum block 6.0 with LS3 heads) and got it tuned. My tuner said the open element "cold air" intake I had...
-
CCalSgt reacted to Snoots's post in the thread New Hinge Alignment with NO Reference Marks with Like.
Long read but, worth it. Preparing the door Install the door hinges on the door and make sure that the lower hinge is in the closed...
-
CCalSgt reacted to bucket's post in the thread New Hinge Alignment with NO Reference Marks with Like.
Install the weatherstripping, but leave the striker out. Install the hinges to the cab and door, but keep all bolts a little loose. With...
-
CCalSgt replied to the thread New Hinge Alignment with NO Reference Marks.3 years only working weekends, every nut, bolt and piece restored or replaced...
-
CCalSgt replied to the thread New Hinge Alignment with NO Reference Marks.Mine is almost done, I need a few bits and pieces then it’s a driver.
-
-
CCalSgt reacted to Russtypickle's post in the thread New Hinge Alignment with NO Reference Marks with Like.
Thanks CalSgt, ya, I knew before I took them off and painted them that it was going to be a grind re-aligning them, I just didn't want...
-
CCalSgt reacted to Snoots's post in the thread New Hinge Alignment with NO Reference Marks with Like.
Painters tape.
