CalSgt's latest activity
-
CWhen I did the LS swap on my truck, I wire brushed and painted the front half of frame while the drivetrain was out. I used VHT Chassis...
-
CCalSgt replied to the thread C10 LS Swap Actual Cold Air Intake.Looks really nice, good job
-
CFinished up my LS swap (L76 aluminum block 6.0 with LS3 heads) and got it tuned. My tuner said the open element "cold air" intake I had...
-
CCalSgt reacted to Snoots's post in the thread New Hinge Alignment with NO Reference Marks with
Like.
Long read but, worth it. Preparing the door Install the door hinges on the door and make sure that the lower hinge is in the closed... -
CCalSgt reacted to bucket's post in the thread New Hinge Alignment with NO Reference Marks with Like.
Install the weatherstripping, but leave the striker out. Install the hinges to the cab and door, but keep all bolts a little loose. With...
-
CCalSgt replied to the thread New Hinge Alignment with NO Reference Marks.3 years only working weekends, every nut, bolt and piece restored or replaced...
-
CCalSgt replied to the thread New Hinge Alignment with NO Reference Marks.Mine is almost done, I need a few bits and pieces then it’s a driver.
-
-
CCalSgt reacted to Russtypickle's post in the thread New Hinge Alignment with NO Reference Marks with Like.
Thanks CalSgt, ya, I knew before I took them off and painted them that it was going to be a grind re-aligning them, I just didn't want...
-
CCalSgt reacted to Snoots's post in the thread New Hinge Alignment with NO Reference Marks with Like.
Painters tape.
-
CCalSgt reacted to PrairieDrifter's post in the thread New Hinge Alignment with NO Reference Marks with Like.
You need the seals to do the alignment. Also pull the striker off the door jamb. You're gonna be taking it off and on a bunch. An engine...
-
CCalSgt reacted to legopnuematic's post in the thread New Hinge Alignment with NO Reference Marks with Like.
My advice is to remove the fenders, or at minimum remove the bolts/loosen core support and pull as far forward as possible. Then with...
-
CCalSgt replied to the thread New Hinge Alignment with NO Reference Marks.Honestly Sir… It’s a trial and error thing to fit doors. Had you asked before I would have recommended fitting the doors first before...
-
-
CCalSgt replied to the thread 80 sq body.Another squircle! Welcome from California too, also just got done with a full resto on a 1980...
-
CI bought those wheels and tires in 1994. Yes, the tires are bad! Trying to decide what to do first.....
-
CI sent mine to precision rubber and they rebuilt them....heard too many stories that it was a pain to rebuild
