Recent content by c5killer
-
C
R4 to Sanden whith stock ac lines(for serpantine)
Here is my R4 to Sanden 4864 conversion. You will notice my burb has been LS swapped. I had the ICT billet R4 bracket. Instead of buying a brand new bracket for the Sanden unit, I elected to buy the Dirty Dingo conversion kit. Of course I had to tweak some of the spacers for the rear mounts... -
C
R4 to Sanden whith stock ac lines(for serpantine)
Do I need to swap out my high/low switch on the accumulator to one for r134A or just keep the R12 one? -
C
R4 to Sanden whith stock ac lines(for serpantine)
This is the info I have been looking for. @yevgenievich, all I can find are the 8 rib clutches for this model compressor. Did you have to special order a 6 rib? -
C
Here for the knowledge!
Hello everyone! I have a '91 V1500 burb. It was a project that someone else started. Has a "4" lift". I know it has 4" blocks in the rear and appears to be stock in the front, maybe 2". I'm planning to go 6" springs all around. Currently has 35" tires, going to go 38" someday. It has factory 10...- c5killer
- Thread
- Replies: 9
- Forum: Introduction
