Recent content by Broken85

  1. Broken85

    New to gmsquarebody

    Beautiful! How do you like the 3:42? I am trying to decide between 3:42 limited slip and 3:73 LS for my K10 cruiser with a 375 HP small block Blueprint motor. I am only going to run 32 or 33’s and average towing, with some highway trips in the future so I am inclined to go 3:42, but I really...
  2. Broken85

    Gas spilling when filling up

    Just a thought, if it’s using that much gas, and you are deleting the spare tire any way for a 40 gallon tank, you could go nuts and make it a three tank system, or keep the saddle and make it a dual tank. It is just wasted space if you don’t. Sounds like that saddle tank has to come down...
  3. Broken85

    4l80e conversion in 1985 suburban. What parts do I need?

    I know this isnt exactly what you were asking but (hoping this helps the next guy), if you ask ChatGPT for a parts list and an order of work to switch a 700R4 to a 4L80E, it will give you a parts list, and a list of mods you need to make for the project to work. I am not naïve enough to think...
  4. Broken85

    700R4 Transmission Questions/Issues

    Bru, I hate (really hate) suggesting this, but you may have burned the clutches out of it already with that cable being so loose. Drop the pan and see what the fluid looks like for a cheap di-ag and the coat of a $30 filter and gasket kit. If it is cloudy and gray and a bunch of gray mud in the...
  5. Broken85

    86 C20 - Climate control not changing position - cable or vacuum operated?

    That is the vacuum line that is most definetly not connected to the vacuum pot it is supposed to and likely your trouble. If it was behind the dash it is probably the bi level pot. I hope you are flexible!
  6. Broken85

    700R4 Transmission Questions/Issues

    Don't drive it if it is slipping until you pressure test the transmission to dial in the TV cable. You will burn up a 700R4 in a few miles if the TV cable isn't right. Was it acting this way before you replaced the TV cable or just afterwards? Adjusted all the way out is also probably not...
  7. Broken85

    Unknown Relay clicking

    Ha!! Ya know, my day is never truly over until auto correct gets me at least once!
  8. Broken85

    Unknown Relay clicking

    That looks like your conscience center. The round relay is your hazard relay. There two; the blinker relay is on the fuse box. I’d say that black relay is probably a horn relay. (yes I shamelessly stole this diagram)
  9. Broken85

    What’s the best way to fix/clean up this wiring problem?

    I don’t know what these circuits are each drawing but if it is less than 30amps, I would recommend this Amazon special. I installed it 6 months ago and no issues. 5 hot circuits, and 6 switched circuits. Connect a hot to the battery and a hot to a switched ignition relay from the fuse box. Power...
  10. Broken85

    4:10 gears for 86 k10

    Revolution looks like quality stuff, but they don’t offer anything under 1988’ or less than a 4:10. Any other companies you would suggest for an 85’ K10??
  11. Broken85

    LED exterior light conversion! not going well :(

    The reason the dash blinker indicators glow with the headlights is also because of the LED bulbs. The 1157s are basically two independent circuits; one for marker and one for blinker. The LEDs are not two circuits. They are one circuit with a high (blinker) and a low (marker) so when you turn on...
  12. Broken85

    Tv cable

    To answer the very first question in this post; Press the detention button on the side of the TV Cable mount near the carburetor. Hook up the cable to the carb and open the throttle to full (engine off of course). This will extend the TV cable to the proper length. FYI, this is only meant to...
  13. Broken85

    Keyless entry upgrade

    I added this little guy two years ago. Wiring wasn’t a major pain and it is still working just fine. Since it triggers the locks by bypassing the switch, it actually is much stronger than using the door switch which in my truck barely has enough power to raise and lower both locks...
  14. Broken85

    LED conversion

    I use these too. They work, but if you have marker lights on the blinker flash is so dim, it is barely discernible. They work great with no marker lights on.
  15. Broken85

    Precision windshield gasket, self locking or lock strip?

    FYI, I paid a guy to put mine in, but I bought the windshield seal with the chrome insert from LMC ahead of time so he would have all the parts. The LMC insert cracked and fell apart when he was putting it in, so I had to revert to the black insert. Hope this saves you a Few bucks and some time...
See more

Latest posts

Forum statistics

Threads
45,557
Posts
986,191
Members
38,640
Latest member
clee
Top