Read the disassembly last night and most of the assembly. Great information. As soon as I have the funds I think I will take a shot at the build. Thank you for all of the information on this site that you have added. All very good and insightful. What kit would you recommend for a rebuild...
Thanks for the info. I am running low on funds to get this thing on the road and the wife is running out of patience using her car to tote trash to dump. I will look into the items you listed and see what i can do. Thanks again.
OK so if it is the clutch pack what rebuild kit do you guys recommend. I have looked around and there are too many out there to figure it out. I would like to go with a good duty kit. I am running 4" lift with 35's and .308 gears. Also while I am at it what gear should I use. I have run all...
Thats right. I only replaced the seals. The transmission was dumping into the tcase and blowing fluid out the vent when i got up to about 45. New seals front and rear drive shaft and adapter plate, new o-ring on input from transmission. Have had an issue with the truck seeming under powered...
Thanks for responding. I do have the coupler installed. I do have reverse. I have been reading alot about people loosing the forward clutch packs and that means rebuild. Hoping its not that. I have had 4 of these trucks in the past but all manual. This is my first issue with an auto.
resealed transfer case. reinstalled and backed out of the garage. That is where it stayed. Put into first gear and nothing. Motor revs but no go. Any suggestions.