Bextreme04's latest activity
-
Bextreme04 replied to the thread Marine 502 into 1984 GMC 2500 454.The iron heads that would have come off it are very good heads, but they will be rectangular port heads and not great at low RPM. I... -
-
I took the carb loose and sprayed them with PB Blaster. They turn now.
-
Bextreme04 replied to the thread Marine 502 into 1984 GMC 2500 454.It's also worth noting that a Gen VII BBC cam will also work just fine, but would change the firing order to an LS firing order. It...
-
Bextreme04 replied to the thread Marine 502 into 1984 GMC 2500 454.No. All of your stuff just needs to match. If he had a factory style hydraulic roller cam installed already, he could just keep that. If...
-
Bextreme04 replied to the thread Marine 502 into 1984 GMC 2500 454.You shouldn't need anything to run a flat tappet. The Gen VI just has the machined boss on the front to run the cam retaining plate and...
-
Bextreme04 reacted to justicemclinden's post in the thread Installed new tachometer and put a 70s fuel gauge in 85 cluster and now truck won’t start any ideas? with
Like.
Whoever was working on the truck before me definitely redid the wiring harness and there is a bunch of bs that has been done and now the... -
It appears you found the culprit…me, ordering a standard flow water pump. It most likely is a coolant flow issue based on whats...
-
Bextreme04 replied to the thread Overheating Rebuilt 350.When I have broken them in on a stand.... no fan, no thermostat, radiator hooked up, output from intake to heater dumping on ground...
-
-
Bextreme04 replied to the thread Marine 502 into 1984 GMC 2500 454.The Marine 502's from the 90's-early 2000's would have almost all been based on Gen VI block architecture. That means one piece rear...
-
Bextreme04 replied to the thread Installed new tachometer and put a 70s fuel gauge in 85 cluster and now truck won’t start any ideas?.Tach in a square will have a separate harness with power/ground connections and a single wire that runs from signal on the tach to the...
-
Bextreme04 replied to the thread Marine 502 into 1984 GMC 2500 454.Pics? Depends on what the "Marine 502" actually is. What the block casting number? Where did he get it from? Is it one piece or two...
-
Bextreme04 reacted to DoubleDingo's post in the thread Radiator Support Bushings: Is this correct? with Like.
I agree with @CalSgt I don't think you need to worry about the frame mounts.
-
Waiting for the parts to arrive today. Even after acid washing the intake, it looked like a$$, stained, etc. So I hit it with some...
-
Something seems missing in your picture. Thought it needed a little something extra.;)
-
Geez Chuck, sounds like me with my motor, some things fit, some don't. Those Brodex Heads, just curious about the specs....Carry on!
