Bextreme04's latest activity
-
Bextreme04 replied to the thread 1983 c30 A/C Compressor Clutch.That's pretty low. What was the high side pressure at? You replaced the orifice tube when you did the conversion? My high pressure port... -
Bextreme04 replied to the thread 1983 c30 A/C Compressor Clutch.That's not how that works. You could have twice the acceptable charge for your system and still have it reading 45PSI. You filled it...
-
Bextreme04 replied to the thread 1983 c30 A/C Compressor Clutch.Unplug the clutch plug and test voltage across the two pins while it should be engaged. Then check voltage(voltage drop) from the ground...
-
Bextreme04 replied to the thread 1983 c30 A/C Compressor Clutch.Also, filling to 45psi on the low side is crazy to me. How much is it taking to do that? You should be filling to 2/3 the recommended...
-
Bextreme04 replied to the thread 1983 c30 A/C Compressor Clutch.Make sure everything has a good ground. The clutch is powered through the low pressure switch and then grounds through a bunch of...
-
Bextreme04 replied to the thread Vapor Barrier behind new door panels?.I just put the butyl tape around the perimeter of the door, cut a too big piece off the giant sheet I bought, then stuck it to the butyl...
-
Bextreme04 reacted to PrairieDrifter's post in the thread Vapor Barrier behind new door panels? with
Like.
Keeps the wind out in cold climates. Get enough sidewind and you can very much feel the cold just pouring in through the door handle and... -
Bextreme04 replied to the thread Latest thinking on replacement gauges.I bought dakota digitals for mine also, mostly because I am doing a motor swap to an EFI system. You can get a full new OEM gauge...
-
Bextreme04 replied to the thread Anyone live in Portland, OR have a shop they like? Need to pass emissions….Look in the glove box for the SPID sheet. It would also have a tag on the driver door frame with the GVW rating or inside the glove box...
-
Bextreme04 replied to the thread Anyone live in Portland, OR have a shop they like? Need to pass emissions….@Catbox runs his through DEQ in Portland and has a 454. You should be fine with dual exhaust, but would need to add in the correct...
-
Bextreme04 replied to the thread Replacement Seat Opinions.I'm using 03-07 Silverado 40/20/40 split bench seat set. I found a set of full power seats in Gray leather for $60 locally. Similar to...
-
Bextreme04 reacted to 83Burban's post in the thread What did I do wrong? NV4500 Swap Issues with Like.
Pilot bush went in for sure after being test fit on shaft. Bought red locktight and new torq wrench just for this the job. Also, I did...
-
It looks like the throwout bearing is grinding in the clutch disc hub. Any chance it's the wrong disc or possibly the disc is installed...
-
Bextreme04 reacted to hoagster's post in the thread What have you done to your square lately?? with Sad.
We'll we got screwed because it was owned out right and they still demanded payment.
-
Bextreme04 replied to the thread What did I do wrong? NV4500 Swap Issues.That should all fit correctly then. The symptoms make me think you assembled something wrong and therefore didn't have the clearance...
