Bextreme04's latest activity
-
Bextreme04 replied to the thread backfire under wide open throttle.Backfiring is going to be timing related or a mechanical issue 99% of the time. How did you set your timing? Have you run a compression... -
Bextreme04 replied to the thread 14bolt FF size vs 10bolt.Yes, the 14BFF yoke is(I think) about 2-3" longer than a 10 bolt one. You will want to check driveline angles also before you bolt...
-
Bextreme04 reacted to legopnuematic's post in the thread Skool me on timing w/o timing tab with
Like.
Just use a piece of stiff wire and bolt it to the water pump or wherever convenient to make a pointer, then find TDC using a piston stop... -
The ICT mounts put the Trans/ Tcase where I wouldn't have to drill anymore holes in frame. It all just worked out better. I measured the...
-
Bextreme04 replied to the thread Questions about... My rear end?.Depending on where you got the replacements, they likely haven't been rotating in many years... maybe even decades. So the fact you...
-
Bextreme04 replied to the thread Tq converter for 5.3 ls swap in a 700r4.There is no way this will be cheaper unless you already have all the parts. You can get full motors for ~$500 around here.. throttle...
-
Mine was leaking in the same spot. Return line rusted just ahead of the rubber hose. There is the feed, return, vent and brake lines all...
-
Bextreme04 replied to the thread Twitchy steering with a big travel trailer (rear sway bar help?).That should be fine for what you are doing here. A bumper pull trailer on a weight distribution hitch will be adding about 1000lbs max...
-
Bextreme04 replied to the thread 5.7 Vortec and TBI.Operating range is idle to 5500RPM.... You don't want dual plane for fuel injected. You get horrible cylinder imbalance and they have...
-
Bextreme04 replied to the thread Eaton MLocker.Its stupid simple. It's just a lunchbox locker like a detroit is, I would probably hate it on a daily, but for my truck it works just...
-
Bextreme04 replied to the thread Leaking Metal Fuel Line??.If it was a hole in the feed line, you wouldn't be able to pump any gas... it would just be sucking air. It is most likely either the...
-
Bextreme04 replied to the thread 5.7 Vortec and TBI.The best solution is to just use the chevrolet performance intake manifold... but it isn't cheap...
-
Bextreme04 replied to the thread What's this dohicky.There isn't an opening into the booster unless the diaphragm is busted. If it did leak out the back of the master it will be stuck back...
-
I didn't think about running denatured alcohol through that weight proportioning valve though...I did push air through to clean out...
-
Sweet, make total sense now. Thanks Brother! @Bextreme04
