Recent content by benscharlotte21

  1. B

    SF drum versus FF drum

    So where would I find brakes for my 87 with a full floater? everywhere I look it seems to be the part numbers for semi
  2. B

    SF drum versus FF drum

    I have a Full floating 14 bolt rear end need new drums. I can pick some up for 60 bucks new from a guy on craigslist but he says they are for a semi floater. Is the drum different? Thanks
  3. B

    Driveshaft swapping?

    With the 6 inch lift I just out in I want to extend my driveshaft. I was thinking though.. Are there any chevy driveshafts that have the same u joints but are already 2 or 3 inches longer? I'm just curious, not sure which direction I'll go with it yet.
  4. B

    Vibration in square body driveline

    Apparently, contrary to what I would do, he decided to take it to the shop. They said u joints and bad driveshafts. So 500 bucks later he should be driving this hulk
  5. B

    Vibration in square body driveline

    Full floating
  6. B

    Vibration in square body driveline

    Pinion angle is damn near perfect. I was thinking also that I would loosten the tranny mounts and re tighten them to see where it fell back down
  7. B

    Vibration in square body driveline

    Tires aren't the issue I had them on my truck prior. We did that and don't see anything but it was night so I'd like to do it gain during the daylight
  8. B

    Vibration in square body driveline

    Okay so my buddy just got a 74 Cherokee with axles out of a 87 3/4 ton. It also has a 305 with the turbo 400 tranny and 208 transfer case. So anyways what happens is it will accelerate fine and then when you let off the gas it vibrates like a bastard. Shaking the whole vehicle. I did the front...
  9. B

    Extended slip yoke

    Basically my question is.. can you get one? After the 6 inch lift i have minimal shaft in the NP205 transfer case mated to the SM465 tranny.
  10. B

    Vibration after 6 inch lift install

    Could my right helper spring being on upside down be the cause? Ive still not mounted the new rims cuz I have to take it to a shop. I'm going to go switch the spring tonight or tomorrow night Im just curious on peoples opinions
  11. B

    Vibration after 6 inch lift install

    Its a bent rim. Probably also why the tire took 19 ounces to balance lol
  12. B

    Vibration after 6 inch lift install

    It's a shake. Basically the truck is going up and down as I drive. I feel like I'm on a miniature bucking bronco.
  13. B

    Vibration after 6 inch lift install

    And John, My pinion is actually pretty square to the drive shaft so unfortunately probably not the issue
  14. B

    Vibration after 6 inch lift install

    could it maybe be a warped rotor on the front left? Though if it was a problem with the front id think it would be screwing with my steering. Just a thought since we hammered the piss out of the steering arm and heated it up as well
  15. B

    Vibration after 6 inch lift install

    Hey just hoping to tap a few greater minds here: Just installed a 6 inch lift in my 87 2500, with no issue EXCEPT for the fact that my rear end vibrates like a bastard. I thought it would be the new 37 inch tires i have but I balanced them and its still there. Maybe even worse actually. Also...
See more

Latest posts

Forum statistics

Threads
42,311
Posts
913,457
Members
33,810
Latest member
Garcjay
Top