ali_c20's latest activity
-
Just cut/split the nuts for the bed bolts, then remove the factory bolts with no chance of spinning and rounding the square hole... -
ali_c20 reacted to legopnuematic's post in the thread What new tools have you got lately? with
Like.
I have a FSI riv nut gun. Military surplus, they were on ebay for pretty cheap some years back. -
Got this RivNut tool today. My Ford buddy had bought bedside cleats for his truck with the cheesiest POS hardware for installing the...
-
ali_c20 replied to the thread New to the party..Welcome from Austria.
-
A few pictures of the interior
-
When I had the front end off to change the inner fender wrlls. I also did a complete detail of the engine bay. NOTE this is when you...
-
I will be needing a tool for adjusting the ball joint sleeves for the 10 bolt project, I decided to whip one up. 1" hex would have been...
-
Well thank you sir. Here's a current Pic. Set the pit box to one side on angle iron supports and you can store stuff next to it. Grim...
-
That little pit box on the right put that in a BBQ grill for your driveway tool box. Comes in handy. You can fit a pit box in the top...
-
ali_c20 reacted to PrairieDrifter's post in the thread What new tools have you got lately? with Like.
Finally got a toolbox, us general 56 inch. It's pretty decent honestly, pretty filled up other than the wrench drawer, have been...
-
Bingo! If it ain’t broke, don’t fix it. While technically the trans is “broke” unless you really plan to beat up on the truck, there...
-
Valve covers, distributor, oil sender, and China wall all like to appear as rear main. Pull the converter cover and look up in-between...
-
ali_c20 replied to the thread Oil Drip Locations (w/ pics).Valve cover leak can look like main seal too. Ask me how I know :D
-
ali_c20 reacted to Ricko1966's post in the thread To fix or not to fix, that is the question. with Like.
It is probably a vacuum modulator. $25.00 part 30 minute fix. No special tools not even a jack if you are skinny like me.
