ali_c20's latest activity
-
ali_c20 replied to the thread New member with a new C10 build.Welcome from Austria. Nice truck. -
Hello all, wife and I picked up a 1979 Scottsdale LWB as our new project. Runs and drives but needs to be checked out. 350sbc/TH350...
-
ali_c20 replied to the thread Time to say hi from Husker Country..Welcome from Austria. Which color have you chosen?
-
After many months of patiently waiting, it's finally in primer, now waiting on paint:
-
ali_c20 replied to the thread Towing with an old truck.Welcome from Austria. Post a pic of your Truck. I use my K5 as daily in the warm months, so much better than new cars.
-
Agree, not sure where some of the depression era “save everything” mentality comes from, especially in this situation. Reading the OPs...
-
I can’t speak regarding any GM transmissions, but the 46/47/48re Dodge transmissions have a temperature sensor that is part of the valve...
-
I'm still running on air. I'll put my Aircat 1150 up against any of y'all's battery powered impact wrenches.
-
ali_c20 replied to the thread TH350 oil level, engine off.2 person job while driving and not everyone wants to drill a hole in the floor of his truck. ;D
-
ali_c20 replied to the thread Center/carrier bearing orientation - 76 C20 suburban.Remembered a thread with pictures of a later model suburban C20 driveshaft...
-
ali_c20 reacted to TheC5Surgeon's post in the thread Center/carrier bearing orientation - 76 C20 suburban with
Like.
There seems to be a built-in little shield on the drive shaft right in front of where the bearing sits. There is nothing towards the... -
ali_c20 replied to the thread Center/carrier bearing orientation - 76 C20 suburban.The bearings in the carriers are often sealed ones or have a dust shield around them in the rubber and are greased. I think the side...
-
ali_c20 reacted to TheC5Surgeon's post in the thread Center/carrier bearing orientation - 76 C20 suburban with Like.
Actually i have the 32 spline shaft so go the D3F kit
-
ali_c20 reacted to TheC5Surgeon's post in the thread Center/carrier bearing orientation - 76 C20 suburban with Like.
Thanks. Just ordered the D3G dust cap kit
-
ali_c20 replied to the thread intro and advice.Welcome from Austria. Damn that sucks. As the tires are intact I think everything under the car is ok. Get a second and build a new one...
Latest posts
-
-
-
-
-
4l80e conversion in 1985 suburban. What parts do I need?- Latest: NickTransmissions