ali_c20's latest activity
-
^^^^ this. You'll spend 1/3 on fuel as you will if you big block swap. And a 6.2 will pull anything you put behind it. -
Howdy from Ohio! How long have you had it? If you drive it a bit more, you may find that you actually like the 6.2, along with it's...
-
Howdy! I just picked up my first square body three weeks ago. I picked up a 1988 chevy v10 suburban, this is my daily driver and it's a...
-
ali_c20 replied to the thread First Square body!.Welcome from Austria.
-
I installed mine with the exhaust manifolds already bolted on. It worked fine, but it was a PIA to jockey it around to line up and...
-
I went through this on my 85 with the help of Magnaflow engineers. Bottom line, if the cats don't get hot enough to fire off, it's all a...
-
In an S2000 I had some time ago an electric pump run for a minute after a cold start on a timer and it shut off during acceleration. I...
-
Yep.
-
I would say absolutely. K
-
ali_c20 replied to the thread Engine install.Yes. More space to work on the engine mounts without them.
-
ali_c20 replied to the thread 1991 c1500 rear axle to 1987 r10.Welcome from Austria. Post some pics. Transmission is direct fit if both trucks have the same transmission. Driveshaft length. Axle...
-
ali_c20 reacted to Zelph's post in the thread 1973 Blazer tailgate aluminum panel restoration with
Like.
I would hit up a hot rod shop or custom car shops and see about having them repair any dents or straightening and maybe do the... -
We converted a '72 C20 to modern 6 lug stuff. What we ended up doing for the front was we got a ball joint reamer and reamed the 1/2 ton...
-
The ENTIRE C20 cross member is about 12 bolts and it drops right out as an assembly.
