83Stepper's latest activity
-
83Stepper reacted to Girth's post in the thread What have you done to your square lately?? with
Like.
First bath and a quick coat of wax. Tightened up the last few bits and pieces to go back on, stuck the Chevrolet emblem to the rear door... -
83Stepper replied to the thread Who sells the best replacement gas tank.Pretty sure I've got an GM11B in mine from Spectre. Seams were a little on the elongated side when putting my new tank straps across it...
-
83Stepper reacted to Drauka99's post in the thread What have you done to your square lately?? with Like.
"BETTER THAN IT WAS" Is the key part of this statement. A lot of people refuse to try stuff because " what if i mess it up", well it...
-
83Stepper reacted to brooksman9's post in the thread What have you done to your square lately?? with Like.
Well, it is black now. Didnt come.out as good as I had hoped but better than it was. Hopefully nothing a whole lot more damn sanding can fix
-
83Stepper reacted to Phillippio's post in the thread What have you done to your square lately?? with Like.
I have been busy on the old truck. -New brakes all around -New front suspension -New tires and shocks -New door and wind window seals...
-
83Stepper reacted to Strick's post in the thread What have you done to your square lately?? with Like.
I finally got another opportunity to work on the '87 again. I got more than half the body molding done. HS
-
83Stepper reacted to fofiddyfo's post in the thread What have you done to your square lately?? with Like.
FINALLY got the (hopefully!!) last leaky fuel line replaced. Today is the first day she’s moved under her own power in well over 5...
-
83Stepper replied to the thread Finally found some 5x5 Turbines!!!.Appreciate the heads up, ran a mic through at least two rims for the shanks now and haven't seen any out of round just yet. There's only...
-
I think what you're going to find once you try to install them is the lug nut holes are elongated from t the wheel coming loose and...
-
83Stepper reacted to BigHossRuss's post in the thread Hello from Vancouver, WA / Portland, OR with Like.
Thank you. The wheel wells definitely are as shiny anymore but thought it looked cool to try and match the paint. Local paint store...
-
Good choice in wheels! I love this design. These are the ones they recommended, you need the 7/16x20 1" long...
-
83Stepper replied to the thread Issue resolved - New parts on the way -- Key will not insert into the ignition switch.Sounds like the ignition switch has potentially failed. If you can't get the key to wiggle into the lock cylinder, sounds like the...
-
Just to put closure on this, it appears my problem is the switch in the column itself. I wiggled the harness coming down from the...
-
It is getting back feed from the parking lights (not uncommon)- usually a ground issue. I always start by checking grounds. Check your...
-
83Stepper replied to the thread Hello from Vancouver, WA / Portland, OR.Welcome, and yeah that's a nice truck for sure! Love the contrast in the engine bay with the black and inner wheel wells being same...
