Recent content by 82chevyk10

  1. 82chevyk10

    Stock K10. What size tire?

    The rut actually goes on up and across the road, where I originally got struck. Thats just the spot where I couldn't back up any further.
  2. 82chevyk10

    Stock K10. What size tire?

    I have 235/75/15's on my truck right now. It's a horrible off road tire. Not enough ground clearance when you get in a rut.
  3. 82chevyk10

    87 SWB 2WD R10 rear gear

    Any chance it may not be a chevrolet rear end.
  4. 82chevyk10

    Is a 2wd 4L60E worth the trouble?

    That's why I just started letting mine ride in the passenger seat.
  5. 82chevyk10

    Is a 2wd 4L60E worth the trouble?

    Go manual. Mine has a few minor problems, but it can't be killed.
  6. 82chevyk10

    Esc?

    I just got finished playing with it a little. The mechanical advance dosen't seem like it's springing back into place real well and a vacuum gauge on the advance diaphram was only reading about 5.
  7. 82chevyk10

    Esc?

    The knock sensor on the side of the block is exactly what I'm talking about. It looks to be original so I'm not even sure if it is functioning properly, though I don't have any engine knock at cruise. If it's not all that important, then I"m all for doing away with it. Simplicity is what I'm all...
  8. 82chevyk10

    Esc?

    I was just doing some distributor research online and got thinking about my electronic spark control. When I put a new engine in I reused my old esc sensor, but the it looked rough, and the wire going to the loom is the same. I really need to do something about it. Would I be better off removing...
  9. 82chevyk10

    Throttle Cable Poll & Talk

    What can I say? Redneck engineering.
  10. 82chevyk10

    Throttle Cable Poll & Talk

    A crack in the insulator caused mine to rust into. Who knew a piece of speaker wire could double as a hand throttle cable. Adapt and overcome.
  11. 82chevyk10

    rough idle

    I don't think it could be the cam and crank marks not lined up. It's a new crate 350 that I put in myself. No internal engine work has been done to it. Could the timing tab be wrong for the damper?
  12. 82chevyk10

    Any engine guys on here

    Read the link and will be buying a vacuum gauge this week. Never knew they could tell you so much about an engine.
  13. 82chevyk10

    How I fixed my boken frame

    I read a thread on here about someone with broke frame at the p/s gear box. I actually had this problem last year, and if I would have know that this was a problem area for these body style Chevrolets I would have reinforced it before it cracked. This was my solution that didn’t involve any new...
  14. 82chevyk10

    Post your toys, square or not

    My '94 Z28. Pic was taken by the previous owner. The wife has a '05 Kia Optima. It runs great, but I just ain't a fan of the imports.
  15. 82chevyk10

    '87 Toyota 22R Knock

    We removed all the belts today and started it. The knock was gone. So the next was what pulley. The crank shaft pulley on them is a 2 pulley design with a third pulley bolted on the outside of it. The third pulley had a lot of movement. We tried to removed the four bolts the held it on. Two came...
See more

Latest posts

Forum statistics

Threads
42,280
Posts
912,861
Members
33,780
Latest member
joshuars
Top