-
-
4I have this 454 that is a clean engine just waiting to be rebuilt and installed in your truck. I was going to use it for my 68 truck but...
-
-
4425HP409 replied to the thread How to get privileges.I am good now, thank You!
-
4I am a new member and need to know how to get sufficient privileges to post in the want ads. I have paid and am a supporting member, but...
-
4I am a retired auto shop owner and automotive technical school instructor. I grew up working in my Father's shop in East Texas. Wanting...
-
4425HP409 replied to the thread 700r4 tv cable adjustment.One thing to make sure happens when you adjust the TV cable is that it will downshift from 2nd to 1st at 20 MPH with full throttle. If...
-
4425HP409 replied to the thread TH350 from '84 GMC w/ 305. Trans appears to be leaking from the yoke on tailshaft..The hole in the end of the yoke is so there will not be a vacuum issue when the spline threads are new. After they wear, fluid can get...
-
4425HP409 replied to the thread 700r4 leaking weephole on yoke.Remove the driveshaft and install a rubber cup plug (like a wheel cylinder cup) into the end of the yoke with gasket sealer. The...
-
4425HP409 replied to the thread Rochester Q-Jet running rich.I would check the float level with a tool to do so with the carb on the engine.
-
4The super hold servo is not necessary unless you're pushing more than 500HP and racing in 4th (or you're actively towing heavy loads in...
-
4425HP409 replied to the thread TH350 will not engage after sitting for three months.that should not have caused any problem. I am leaning to fluid level.
-
-
Loading…
-
Loading…
