pinballlarry1
Supporting Member From Kalispell, Montana
- Joined
Latest activity Postings About
-
-
pinballlarry1 reacted to redneckgames's post in the thread New Dad/Daughter Project 78 Cheyenne with
Like.
Just joined the site to use for references and troubleshooting as we build a truck for my daughter. I bought this truck from my cousin a... -
pinballlarry1 replied to the thread What new tools have you got lately?.Refurbished my Craftsman 328.12020 2.25 ton floor jack, made in the '70s. Heavy duty, made in Japan model, $49 repair kit and 9 hours of...
-
-
pinballlarry1 replied to the thread 1981 fuse box.This is my '81 C10, 6 cylinder, no A/C: Owners manual:
-
-
pinballlarry1 reacted to CoggedBelt75's post in the thread What have you done to your square lately?? with Like.
Last night I pulled the dash bezel off to fix a crack in it that has bothered me for a long time. It was at a thin piece of the plastic...
-
pinballlarry1 replied to the thread What have you done to your square lately??.4 new Goodyear Wrangler tires installed at Discount Tire, $480 out the door with veteran discount. Very happy with the look and ride...
-
-
I am Mike Knepley, I have a 86 Silverado, all original sheet metal truck! Bought out of Alabama rust free, stripped to bare metal and...
-
-
I don’t have anything useful to add to this discussion, other than my Random Thought. Personally, it’s my opinion what comes out of...
-
Back to working on the 1981 C10 truck. When purchased, the spare tire was just tossed in the bed. I finally paid some attention to the...
-
-
pinballlarry1 replied to the thread Help with the name of this part and what does it control..When it is pulled "on" by vacuum, it opens a flapper that allows exhaust gases to heat the intake manifold area right below the...
-
-
pinballlarry1 replied to the thread What have you done to your square lately??.Got in several hours of work while the wife was away. Changed the gear oil in the 4-speed manual trans, a full one gallon drain and...
-
-
pinballlarry1 replied to the thread Cowl area cleanout, are these fasteners the original correct ones FINISHED!!.Spent 3 hours working today and got it finished, no real problems, just small parts and lots of patience: The rubber hinge seal...
-
-
pinballlarry1 replied to the thread Cowl area cleanout, are these fasteners the original correct ones FINISHED!!.Email sent to AUVECO, awaiting a response. Finally had a warm (60 degree) sunny day today so I spent time working inside the cowl area...
-
-
-
Loading…
-
Loading…
