59840Surfer's latest activity
-
59840Surfer replied to the thread Rear axle replacement.If you have the cover off - the gear count is OEM-stamped into the outer periphery of the ring and on the inside stub of the pinion... -
59840Surfer replied to the thread New diff carrier bearings, anybody heard of Iljin?.I've seen the Amps go down when bearings finally get lubed. We had motors hidden in the ceiling and walls at a hospital I worked at in...
-
59840Surfer replied to the thread New door seals, new problems..The striker-latch is somewhat adjustable and might correct that --- but having just done full-rubber on all my windows and doors --- I...
-
59840Surfer replied to the thread What is this relay looking module box on my valve cover??.That appears to be a Goodwrench replacement engine --- perhaps? The relay was originally spot welded on the old valve cover and if you...
-
59840Surfer replied to the thread What is this relay looking module box on my valve cover??.Too small for a dual battery setup. This is, at most a 10Amp relay. My '86 K5 Blazer had the same relay -- it was a CARB/CalEPA...
-
59840Surfer replied to the thread Gelled fuel or bad pump?.A few things come to mind --- I worked with the USN in Alaska on the diesels and had a few troubles not unlike yours. What Grade of...
-
59840Surfer replied to the thread New diff carrier bearings, anybody heard of Iljin?.I was an expeditor for a cryogenic gasses company during 1962-3 and they had such a hard time even getting bearings (VietNam war 'n all...
-
59840Surfer replied to the thread new from central idaho.Yes it is --- I have been to/through it several times ... next week I go to Nampa. Pray for me.
-
59840Surfer replied to the thread new from central idaho.Montana 59840 says: "Hi".
-
59840Surfer replied to the thread Are rubber valve cover gaskets JUNK? Pic inside.I have used a lot of Mr. Gasket versions and like them a lot. Next up is FelPro cork composition as they are stable and firm enough to...
-
59840Surfer replied to the thread Lost my rear end..It's a few days past my self-induce deadline to put this together --- and I've had two trips to Nampa Idaho and the snow and the almost...
-
59840Surfer replied to the thread Rear axle replacement."IF" being the operative here --- it doesn't always work out that they've been changed - especially when it means two gear sets. The...
