Search results

  1. AyWoSch Motors

    Vortec bottom end/TBI top end: timing?

    What i would do, is roll the engine over to TDC. Put a straw or something down the spark plug hole,or if you have a bore scope even better. Get the cylinder right at top deap, and middle of its dwell period, and see where your timing mark on the balancer sits against the timing cover. If it...
  2. AyWoSch Motors

    5 speed 4x4 transmission

    Fun fact about the NV3500/HM290. It has an identical case lenght and mount style as both a 4x4 700r4, and the later SM465 with the long 6 bolt round transfer case adpater. I took lot of measurements and itd be a near direct swap for both my 92 burb and my 86 k1500. Good to know for those who do...
  3. AyWoSch Motors

    5 speed 4x4 transmission

    They did come in 4x4 style, thats what mine and my back up trans are. Just a matter of finding one is the hard part Im sure. As far as converting a 2wd one, you would need the 4x4 output shaft, and you'd need to take it all apart and rebuild it to swap the output shaft. You'd also need the...
  4. AyWoSch Motors

    5 speed 4x4 transmission

    As far as relatively common to find, and easy to install with little to no modifications needed.... NV4500. 92 to 98 that i know of, but i think they came in the NBS and Cateyes too.Pre '95 had a granny low 1st, post '95 had a higher gear 1st. All were OD 5th. NV3500 or HM290 would bolt up as...
  5. AyWoSch Motors

    Paddle / Camper special mirror gasket and glass replacement

    Those look familiar, haha. Well if they were for me or one of my toys, i would gladly buy them back from you, but these are going for a client. And he won't care if they're original or the cheapy plastic ones, so i think ill go that route. Plus i know this guy,im sure he'll smash them off in...
  6. AyWoSch Motors

    Show your daily driver

    Picked this up resently, been my back up daily, since my caprice is down. 2003 Yukon XL, 2500. Has the monster 8.1L big block in it. 3/4, 4x4, towing package. Things a beast. Hauls ass, tows great. Can't outrun its gas gauge though, haha. So comfy though, rides like a caddy. Its loaded, was...
  7. AyWoSch Motors

    Show your daily driver

    My daily, my baby, best truck I've ever owned. I go everywhere and do everything in this truck. Ive put some miles on this puppy. 1998 cheyenne k2500. The 8600gw HD flavor. Vortec 350, 5 speed stick, 4x4, 3/4.
  8. AyWoSch Motors

    Paddle / Camper special mirror gasket and glass replacement

    I may go with that option. I have one of those cheapy mirrors in my stash, and i think they sell them at my local parts store. Thatd be easiest..
  9. AyWoSch Motors

    Paddle / Camper special mirror gasket and glass replacement

    This is what im working with. And no, they're not on a squarebody, but they used to be, haha. Came off a 75 C30 dually at the junkyard. Currently on a 68 Dodge W300 Power Wagon dump truck. I retro fit...
  10. AyWoSch Motors

    Paddle / Camper special mirror gasket and glass replacement

    Haha, thats funny. That made me smile. Life's just been very hectic and very busy. Lot going on, been in a weird head space. All is well, just trying to get back into the swing of things. Good to check back in for a bit. And yeah, hes not been super text chatty either, hahaha.
  11. AyWoSch Motors

    Paddle / Camper special mirror gasket and glass replacement

    Good idea. The gasket is the hard part though. Nothing to mount the glass to
  12. AyWoSch Motors

    Paddle / Camper special mirror gasket and glass replacement

    I don't have an actual picture of mine, i could get one tomorrow though.
  13. AyWoSch Motors

    Paddle / Camper special mirror gasket and glass replacement

    This is the style I have....fyi. (Stole this pic from another thread, haha)
  14. AyWoSch Motors

    Paddle / Camper special mirror gasket and glass replacement

    Hi. I have a set of Camper Special Mirror frames, that are just empty shells, that im trying to fix. No glass, no rubber gasket. Ive never changed out this style of mirror. where can you get the rubber gasket and the glass? What is that gasket even called? I cant find it anywhere online. Also...
  15. AyWoSch Motors

    Nv3500 into an 86 k10, but not a normal swap.

    Yeah i was suprised too. My 98 is a 350 vortec. Im glad i measured the distance to the throwout bearing before i installed the trans
  16. AyWoSch Motors

    Nv3500 into an 86 k10, but not a normal swap.

    Thats awesome to know. That saves me having to figure out what to buy. And i actaully have the old pressure plate off my 98, it might work. It looks like the one in your picture.
  17. AyWoSch Motors

    SM465 swap into 92 suburban.

    My buddy has a c20 service rig with ridiculously under geared rear. He cruises around and does burnouts in low. We've done 140 in that thing on the highway.
  18. AyWoSch Motors

    SM465 swap into 92 suburban.

    My 86 is 4:10 rear, and i use low gear 1st alot. Usually around the yard or when towing. Not usually in town just driving around. In my burb it should be even more usable.
  19. AyWoSch Motors

    Nv3500 into an 86 k10, but not a normal swap.

    That is a good thread, i didnt find that. Thank you
  20. AyWoSch Motors

    Nv3500 into an 86 k10, but not a normal swap.

    So you kept your stock 80s flywheel on your truck, and only changed pressure plates? That worked okay?
  21. AyWoSch Motors

    Nv3500 into an 86 k10, but not a normal swap.

    On that truck, the stock 98 flywheel was offset really far to the block. The difference between a 98 and 95 flywheel was almost a half inch. Between the flywheel, amd pressure plate change, it was about inch and an eighth thicker..
  22. AyWoSch Motors

    SM465 swap into 92 suburban.

    Could you take a pic of it, if you get a chance? No rush.. I have a stack of bellhousings, wondering if i have one. Doubt it but who knows.
  23. AyWoSch Motors

    Nv3500 into an 86 k10, but not a normal swap.

    Ah interesting. I was wondering. I just recently replaced the NV4500 in my 98 with one from a 95. I figured one for one swap, be easy. Nope. 95 is an external slave, 98 is an internal slave cylinder. Required me to get a new flywheel, clutch, and pressure plate. Bellhousings don't swap...
  24. AyWoSch Motors

    SM465 swap into 92 suburban.

    Understood. Thanks. Ill shop around here first, see what i can get. I do have a friend thats good at welding aluminum.
  25. AyWoSch Motors

    Nv3500 into an 86 k10, but not a normal swap.

    I gotcha.. I have the orginal 11inch clutch and pressure plate off my 305. I should bolt them up to a flywheel and put them in the trans, see if they fit well..

Latest posts

Forum statistics

Threads
48,667
Posts
1,074,231
Members
43,339
Latest member
Jeremy89
Top