Search results

  1. pgnavy

    All Lights are Pulsating

    OK, I am buying the Delco 12SI alternator rebuild kit (again) that includes the diode trio and the regulator....$24. Will give these a try. thx Paul
  2. pgnavy

    All Lights are Pulsating

    What do you guys think....ALL lights in my 87 V1500 have a very slight but noticeable pulsation; headlights, dome light, etc. The pulsing does not go fast or slower as I rev the engine, its just a constant slow rolling pulse. The battery is 12 months old and cranks the engine very well, clean...
  3. pgnavy

    NP208 Speedo Driven Gear Needed

    Good news - the new 44 tooth gear got me to 1MPH accuracy. I suppose the important learning is to measure the tire diameter while on the truck, on the ground. The difference in manufacture claimed diameter (30.5) was off by 2", (28.5). What perplexes me is the GM parts book says I need 42...
  4. pgnavy

    NP208 Speedo Driven Gear Needed

    As promised, an update.... I have a GREEN driven gear(42 tooth), and a BLUE Drive gear(18) in my NP208C (OE according to my GM parts book). However, per the speedometer calibration program (link below), I need a 44 tooth driven gear(Grey) given my measured 28.5 diameter tires/3.42 rear ratio...
  5. pgnavy

    NP208 Speedo Driven Gear Needed

    Hey all, my speedometer is off by 4 MPH (too fast) at 60MPH, confirmed with GPS and a chase vehicle. I have stock rims (15x8) and tires 31x10.5. This is 87 V1500,700R4, NP208, w/GU6(3.42), 53K original miles; I bought this truck a few months ago after it sat mostly since '05, and I've done a...
  6. pgnavy

    How to fix loose gm steering column

    HELP needed....while using this awesome summary to get to the four loose screws in my '87 V1500 w/tilt, these 2 parts fell out onto the floor....I'm like "huh", what was that sound of parts hitting the floor?! Now for the life of me, can't seem to find out how to get them back into the...
  7. pgnavy

    heater core

    My friend replaced his leaking copper core, with aluminum, and the heat was TERRIBLE. He replaced the aluminum with a new copper core and it made a significant difference and now heats properly. Keep in mind it gets to 10 degrees somewhat regularly in upstate NY. His '87 c20, no AC, worked...
  8. pgnavy

    Recomendation for Rockers and Floor Pan

    Hey there, new to this board, and would greatly appreciate some help locating a local shop in the New England area (Mass) to install rocker, floor drivers, cab corner (shown below), the support bracing too. Thanks in advance for recommendations. I have all the panels and 2 support braces. I am...

Latest posts

Forum statistics

Threads
41,849
Posts
903,434
Members
33,362
Latest member
Dhatch84
Top