Search results

  1. 8

    camshaft choice

    Alright, I know I've got a lot of questions on here. But, here we go again. I've got a bf goodwrench crate motor SB 350. It has stock heads. Double roller timing chain/gears. Has an RV cam in it, with hyrdrolic lifters. Also has headers, edelbrock 2101 performer intake with edelbrock 1406...
  2. 8

    cragar ss wheels

    So I finally got some tires on my cragars. 15x6, 5 on 5. The problem I have is that the wheel stud holes are wallowed out to where when you screw the wheel nuts ( cragar Ss mag short shanks) on, they have almost a 1/16" play in between the wheel hole and lug nut on all 5 holes.... I don't think...
  3. 8

    camino wont start

    Ok, went to put my distributor in today and after I got it all back together. It won't start. Did it the right way. Pulled #1 plug, pulled the distributor, turned the motor over with a breaker bar til I felt my thumb being blown off, slowly cranked it to where the timing mark lined up with "0"...
  4. 8

    intake choices

    Right now I am running an edelbrock 2101 performer. What I am thinking about putting on is a weiand 8016 stealth. Performer, I believe, is a midrise. Stealth is a highrise. Both are dual plain. Question is, will I notice any power change if I were to run the stealth?
  5. 8

    muffler choice?

    Ok, I have put 40 series flowmasters on my 77 c10 350 SB. Long tube headers with 2 1/2" pipe, center in center out with about 22" after the mufflers, slightly turned out towards the front of the rear wheels. I've had to have to new sets pit on already. The first time they lasted about 6 months...
  6. 8

    hard starting

    Alright. I've got a 350 SBC. I put a new edelbrock performer 2101 manifold on today. Dropped the dizzy in and now the motor lags like its out of timing. Most likely is. It starts, just lags the first try. I've heard that means it out of time. Did I not drop the the distributor in right? Dropped...
  7. 8

    motor vibration

    I have a SB 350. Pretty much stock, other than mild cam and an accel super coil. I have recently put on new valve covers (chrome w/ Chevrolet on them, dunno if that matters). Took them of my dads elco. Noticed, where the oil breather cap and pcv valve seat in, there was a whole rubbed in the...
  8. 8

    motor mounts

    Alright. I'm still new to the 350 SBC scene. I have a 77C10 350 SB. My question on the motor mounts is, one, will it cause a loss in power. And two, will the vehicle feel like it has more vibration to it?

Latest posts

Forum statistics

Threads
45,583
Posts
986,860
Members
38,672
Latest member
Knightewulf
Top