Search results
-
C30 front suspension components on a c10
Bucket and blues are more knowledgeable on this one for sure, didn’t realize how many differences there are with the a frames- Tank6x2
- Post #2
- Forum: Tech Discussion
-
New guy, father and son from CA
Welcome to the show and tell for adults coming from Edmonton Canada, nice bones so far, keep up the good work and we’re all pic horrs around here ;)- Tank6x2
- Post #2
- Forum: Introduction
-
-
73 c10 Windshield wiper switch back-light
Try brothers trucks, lmc or a wrecker will usually have one- Tank6x2
- Post #2
- Forum: Gauge, Speedo & Instrumentation
-
-
-
-
-
What have you done to your square lately??
Likely, if I had to guess, I would say what you’ve said here or - you put too much heat into it all at one time -
What have you done to your square lately??
Made a welders helper tonight -
What have you done to your square lately??
Been modifying the back side of my hood, hopefully closer to finishing this endeavour this weekend and then on to the window cowling. -
Trans/Transfer Case Combo Opinions Needed
I’m not sure what your unicorn looks like but this one is 400$ Canadian/ 275$USD not sure if it’s what your after though. https://www.kijiji.ca/v-transmission-drive-train/hamilton/np-241-c-np-231-c-4-x-4-transfer-case/1422042973- Tank6x2
- Post #2
- Forum: Transmission & Transfer Case
-
Speedometer Cable
Can you pull the other one if it needs to be swapped anyway and measure it?- Tank6x2
- Post #2
- Forum: Automatic Transmission
-
Valuable car insurance information for squarebodys
Good little blurb thanks!- Tank6x2
- Post #2
- Forum: Tech Discussion
-
1984 K10 Water Temperature Gauge Malfunction, Max Out Then Drops
Check the eyelit connection clean it and restest it, could be the sensor, could be the printed circuit board on on the back of the cluster.- Tank6x2
- Post #2
- Forum: Tech Discussion
-
-
-
-
Replace idiot lights with gauges.
You may need a new circuit board for the cluster, obviously the gauges and may possibly need to run additional wires in the harness to each function/component depending on how your unit was originally wired and installed. Best bet is to grab a circuit diagram off of the forum here, figure out...- Tank6x2
- Post #2
- Forum: Gauge, Speedo & Instrumentation
-
-
Door latch
Any chance the door opened abruptly since you’ve owned it, ie: wind day and flung open- Tank6x2
- Post #2
- Forum: Introduction
-
Muncie 4 speed grinding
You K.I.S. ? Check the lube level in the Muncie by chance? How about lube level in diff? Lift the pumpkin and see how quickly the opposite wheel turns - maybe a bit of preemptive playing the gears of the diffs- Tank6x2
- Post #2
- Forum: Transmission & Transfer Case
