Search results

  1. F

    Woosh sound

    Leaking master cylinder usually ends up with fluid inside the booster which breaks down the rubber causing a brake booster failure. I had to replace both on my truck.
  2. F

    Woosh sound

    Its not a hard job or big really. The hardest part is crawling under the dash to undo the linkage to the break pedal.
  3. F

    Woosh sound

    Brake booster is bad.
  4. F

    My red line is... 3k?

    points or hei ignition? If hei check your plug gap is correct.
  5. F

    Patching between seat and rocker

    Guaranteed your inner rockers are 100% shot. Should probably crawl under the truck and take a visual inspection because you may need a cab support too.
  6. F

    Whats all needed for a 4 inch lift?

    Put it this way... Lots of people compare Pro Comp and Rough Country as one of the same. And I will simply state I do NOT enjoy my truck with Pro Comp springs in the least bit and in fact I all but refuse to drive it because of how hard it rides.
  7. F

    REALLY need help here

    I just explained to you how the two sticks work. Just since I'll be a nice guy and do some googling.. http://s52.photobucket.com/user/metaltwister/media/74%20FSJ%20Jeep%20Cherokee/shiftts.gif.html
  8. F

    REALLY need help here

    NP203 = Full Time NP205 = Part Time/Selectable NP203 has 1 shift lever unless it was twin sticked. In which case one stick will control the locking mode and the other stick controls the shift mode. There are two types of part time kits for the NP203. First kit is the entire assembly which is...
  9. F

    205 very hard to shift

    Not sure where you live but if the temps are below freezing and the wrong oil is used in the transfer case it could cause horrible shifting too.
  10. F

    305 wrong cam

    Don't forget with a cam swap you're going to need a lot of stuff.... cam, lifters, rad fluid, oil etc. Cam change is going to add up pretty quick.
  11. F

    1979 K10 swap

    Entire front clip needs to be swapped across.
  12. F

    87 Silverado 5.3 vs sbc 400

    Sell the LS and install a EFI setup on the 400
  13. F

    Dead Battery Trying to Jump

    The problem with these types of batteries is that when they fall under a certain voltage limit they are almost impossible to get charged again. Lots of people in the motorcycle community run into these issues when they use these types of batteries and their charging system isn't good enough to...
  14. F

    Stupid valve cover gaskets

    I used fel pro blue valve cover gaskets and I'm using a set of $25 "chrome" valve covers. You need to make 100% sure that both surfaces are clean and NOT smooth. I took some 220 grit sandpaper to the inner lip of the valve covers and made sure both surfaces were spotless with acetone. And then...
  15. F

    Rock sliders

    You won't find them for sale because they need to be custom made as our fuel tanks are in the way.
  16. F

    headlights

    Why not take the time and do it properly and figure out the wiring? If your going to put in a switch your half way there.
  17. F

    Getting RPO codes for my truck

    VIN != RPO Code If the code is not in the glovebox or the inner fender then either its missing or parts were swapped. You can try GMC Heritage if you want the codes but this is not guaranteed.
  18. F

    Lift Sizes

    Don't do spacers... NO NO no. Proper backspacing is key.
  19. F

    bucket to bucket seats

    Bench seats were more common. Don't get me wrong I enjoy having my high back buckets but they also do have their downsides. Some days I do wish I should go back to a bench seat and other days I prefer having my buckets. I paid $50 for my buckets with the console so I got a steal of deal and all...
  20. F

    bucket to bucket seats

    I swear I read it more than once. I didn't think our generation of trucks came with low backs and was only in the older trucks.
  21. F

    bucket to bucket seats

    Yes but try finding truck brackets. Those are next to impossible to find. Yes they are comfortable but in the cold they suck LOL.
  22. F

    bucket to bucket seats

    Buckets do not bolt straight up unless they came from a truck. Burbs and Blazers have different floor pan compare to the trucks. Look at my build thread for ideas.
  23. F

    Put Some Used Aftermarket Aluminum Wheels On My K20 - Help ID'ing

    Old tires looked better as they filled the fenders better. New ones I don't like so much but that is simply because I think our trucks look best with a 15/16 rim. A 17" rim just doesn't give enough meat to the tires unless you put huge rubber on then you have to crazy things to your truck.
  24. F

    gauges

    You never said you did that. You just said you replaced some gauges.
  25. F

    Looking for Wire Separators

    Any parts store will have brackets and separators for spark plugs. Just be careful because of them are too small or too tight and will mark up or leave impressions in the plug wires.

Latest posts

Forum statistics

Threads
45,582
Posts
986,854
Members
38,672
Latest member
Knightewulf
Top