Search results
-
...FNG Newbie...
:welcome:...from Husker Country. A diamond in the rough.- Sad Sack
- Post #2
- Forum: Introduction
-
-
-
Brake Fluid Flush GMT800
Some GM ABS systems need the GM Tech2 dealer scanning device to engage the ABS modules solenoids for proper bleeding, whether that pertains to your situation I do not know. I had a 07 Vette that I gravity bled the system and then slow bled after reassembly, but brakes just didn't feel right so I... -
-
backfire under wide open throttle
If no spark, remove the dist cap and make sure rotor is turning. Test ignition module at your nearest autoparts store. Rare when coils fail but they do and are fairly cheap so swapping coil out may be something to try. Then dead-time the engine using TDC technique and confirm wires are correct...- Sad Sack
- Post #16
- Forum: Carb Fuel Systems
-
-
-
1988 Camaro
Well, if two blades can work on a razor why not a windshield...:shakehead:- Sad Sack
- Post #24
- Forum: Other Vehicles
-
-
1988 Camaro
And as a matter of fact I bought an '82 Z28 and those red ones were installed from PO and they came off fast after I got done laughing at them.- Sad Sack
- Post #22
- Forum: Other Vehicles
-
Why can’t I post wheels for sale?
Make sure ya post in "wheel time". :hahano: -
1988 Camaro
I remember those, they were also known to create undue stress on the wiper motor.- Sad Sack
- Post #19
- Forum: Other Vehicles
-
Should i or shouldnt i?!!
Will those seats fit in a squarebody?- Sad Sack
- Post #27
- Forum: Other Vehicles
-
-
-
Engine High Pitch Whining
Had whine issue similar to yours, was driving along and girlfriend says "you hear that whiney noise?", I said yeah, stopped the truck and told her to get out, problem solved.- Sad Sack
- Post #7
- Forum: Tech Discussion
-
Wobbly power steering pump pulley
I assume the squeak goes away with the P.S. belt removed and for what it's worth, for about $80 you can replace the pump, pulley and belt using existing reservoir. Less hassle IMO. If that doesn't correct it, there may be possibly an alignment issue with the brackets and spacers.- Sad Sack
- Post #2
- Forum: Tech Discussion
-
-
Time to say hi from Husker Country.
After many months of patiently waiting, it's finally in primer, now waiting on paint:- Sad Sack
- Thread
- Replies: 5
- Forum: Introduction
-
What have you done to your square lately??
Finally in primer waiting on paint. -
-
Are front wheel bearings adjustable?
IIRC...Jack the front end up and place stands under the A-Frames, get a long bar then slide under tire and lift up. Using a dial gauge against the side of the wheel (may take some ingenuity here) you shouldn't see any movement, please chime in but if more than .006" - BJs need replaced. Please...- Sad Sack
- Post #35
- Forum: Suspension, Steering & Brakes
-
Body repair panels
Order now while you can, most of these items come from China. I imagine stocks will dwindle soon and what is on hand may be limited with restocking being possibly problematic. As for aftermarket, premium is the only way to go and AMD is top notch. One member, I think it's TotallyHucked, works...- Sad Sack
- Post #11
- Forum: Tech Discussion
-
