Search results

  1. C

    Hood hinges help,maybe not the same old stuff

    I don't even know how many 70's square bodies I have had. I only have 4 right now. I always close the hoods with one hand. That's just the way they are supposed to work. I have never bent a hood, and I doubt most people could bend a hood with one hand. I wouldn't invest money for some...
  2. C

    Tire Recommendations

    I run BFG KO2's on all my 4x4's. I find them to be long wearing and quiet on the road and very tough off road. I have no reason to try anything else.
  3. C

    Oil Sample low Viscosity

    Probably so, it didn't like cheap oil. That was the only time the oil light came on when I owned it.
  4. C

    Summit bolt on exhaust system?

    I have used the Dynomax kits many times. I like them and that's all I buy.
  5. C

    Oil Sample low Viscosity

    I tried some Carquest oil in my Cadillac Deville. It was on sale. The oil light came on at idle on like the 2nd day. I ran it for a week or so and then I drained it and put some name brand oil in it and the oil light didn't come on. I don't really trust the parts store brands. Your low...
  6. C

    Oil Sample low Viscosity

    Is this quality oil or economy oil?
  7. C

    1985 K10 Radiator Core 19" vs 17", which do I need?

    I was surprised that my K20 came with a 17" radiator. I think the majority use that one. I'll see if I can double check that tomorrow
  8. C

    Good sound with one pipe only

    I heard a Dodge pickup with a single Thrush welded muffler and thought it sounded great so I bought a pair for my truck. A single exhaust can sound good sometimes.
  9. C

    Inconsistent tapping from 400 sbc

    I don't want to be a jerk, but maybe I am. I don't trust anybody's valve adjustment. I can only do it with the intake manifold off or the dreaded engine running valve adjustment. When people tell me their valve adjustment procedure with the intake manifold on, I just roll my eyes and say...
  10. C

    Death wobble

    I'll bet the tires are ancient and flat spotted.
  11. C

    77 C15 305 hesitation off idle

    No mention of accelerator pump?
  12. C

    Rotate 350 «backwards»

    The tool used to be cheap when I bought mine. How much do they cost now?
  13. C

    454 shake and noise troubleshooting

    That's a sad story. When people are learning on your vehicle you never know how it will turn out. I wonder if the float is acting up. I have a friend that is ANAL about never turning a carb upside down because he is afraid of the float hanging up. I have done it quite a few times but ya...
  14. C

    73-87 Rear Disc Brake Conversion Problem

    That has to be too tight. I would at least adjust it so the wheel turns easily and let the park brake work as crappy as it wants to. If the pads drag that will heat up the pads and rotor and drag even more and just cause headaches.
  15. C

    Quadrajet Secondary issue?

    sounds like it is starving for fuel until the secondaries kick in.. The power piston might be stuck.
  16. C

    Knocking/ticking noise after oil pan gasket

    Well, even though the engine didn't start, it sure sounds like a real bearing knock to me. If it is super loud while running and nobody can tell where it is coming from, that doesn't sound good. This should not have happened by just replacing the rear main seal but I'm afraid something went...
  17. C

    73-87 Rear Disc Brake Conversion Problem

    That's a pretty interesting procedure for adjusting the park brake. I have had my Cadillac for 30 years and worked on the rear brakes a few times over the years but I don't recall reading about adjusting the park brake arm in the service manual. My rear brakes have always felt more than...
  18. C

    1974 NOS doors.

    There is a set in Maine for $1000 for the pair. that seems high enough.
  19. C

    Sbc 350 lifter tick help

    I can't think of any plastic parts in the fuel pump but hopefully that is all it is and that would make the most sense considering that is the area where you found it.
  20. C

    dies at low idle speeds, when put into gear and when stopped.

    A vacuum leak will cause that but it could be a lot of things. I wonder if the ignition and carb/choke is tuned to spec.
  21. C

    Rough country lift

    Tuff Country, Rough Country. I always get them mixed up. I did buy Tuff Country EZ ride springs and they are plenty stiff for me. I wouldn't want to try anything stiffer.
  22. C

    84 K10 full exhaust replacement

    If money is no object then get some Heddman Elite headers. They are heavy duty and fit well. I used to have them on my truck for 15 years then they rusted out. New ones are out of my price range. I always buy dual exhaust kits from Summit. I think they are Dynomax, those fit well too. Then...
  23. C

    Drag limited

    Most square bodies with 3:08's easily rev past 3k in 3rd gear. I'd say it is leaning out for whatever reason. When mine lost the fuel pump lobe it wouldn't rev but I can't remember where it was topping out. My fuel pressure was 1 1/2 psi though.
  24. C

    Rust coating for fill neck

    The thing that scares me about epoxy primer is that I painted the underside of my truck bed with epoxy primer and it is peeling off in sheets. I would hate to have that kind of problem inside the fuel fill area. I have had good results with epoxy primer in other areas but if you have a screw...
  25. C

    1989 R3500 Hitch recommendation

    I bought a nice class 5 on etrailer.com. I can't remember the brand but I wanted the B&W and settled for the cheaper one. It's still a beefy beast. I don't know if there is something unique about the 89 r3500 though. etrailer.com has the best selection at the best prices.

Latest posts

Forum statistics

Threads
48,671
Posts
1,074,268
Members
43,343
Latest member
Joestreml
Top