Search results
-
Introduction and BBC to SBC???
:welcome: You will need most brackets. Do to the size and with of the two blocks. Alt brackets BB and SB two different sizes. IIRC the power steering lower brackets are the same, the upper adjusting bracket is different. Like mentioned earlier the A/C brackets are way different, and depends on...- Mr Clean
- Post #9
- Forum: Introduction
-
Chrome bumpers comparison ?
I was going to say AMD. On somethings they are a bit higher. But their quality is better than just about anyone out there. Re-chroming is out of the question for most- Mr Clean
- Post #6
- Forum: Introduction
-
-
What new tools have you got lately?
While cleaning and rearranging my shop yesterday, I was moving my drill press and the stand i had it on came apart sending the press crashing to the shop floor. Needless to say drill presses are not meant to bounce off the ground. Found a floor stand drill press on FB market. It's an older... -
Garage upgrade
I guess this falls under this category. I cleaned and rearranged the shop today. Put the Extracab cab over in the corner that just had a bunch of crap stored in it. Swept for what seems like for hours. Was going to mop but the wife called and asked if I'd make supper for her and her friend. Not... -
What have you done to your square lately??
That's what I'm thinking -
-
What new tools have you got lately?
I may need one of those pullers.... -
-
-
Gauge cluster.
Have the Gauge cluster out of the 87 Blazer. It was TBI. Looks to be in good shape just needs to be cleaned up. Hit me up if you need it. -
Scores from DIY Parts Yards, Pull A Part, U Pull It etc
Went to a auto Swap Meet today. Found a few goodies. Seats for the Mistress, Hi Lift jack for the Extracab. Small cap HEI distributor brand new. 220 extension cord. Steering wheel spinner for my bead roller. A shift know i thought was cool. Almost bought a 57 Chevy... but the wife said NO!!!!! I... -
What have you done to your square lately??
I'm happy to hear that you found a shop that seems like they know what they are doing. Super stoked you got it back running like it should. -
What have you done to your square lately??
Gutted the Mistress today. Tried not to rip and tear the wiring out. Then it became a moot point after I saw how bad the rats or mice chewed on the under dash harness. Still tried not to screw up the connectors. Looks like a wiring harness is in the future. Removed the E brake assembly just... -
What have you done to your square lately??
Yes sir, you are damn lucky that didn't decide to let go. -
What have you done to your square lately??
Got the A/C junk out of the way. Started mock-up for the firewall, and fitting the fender covers... -
What have you done to your square lately??
I didn't think about the 15s. I have 18s on my Tundra. 15s are like 16.5. Getting hard to find. -
What have you done to your square lately??
Maybe next time look into the metric size tires. I ran 35s on my Tundra. When it was time to replace my tires, the tire shop suggested going metric. He said the metric was 1/4 inch smaller, and 1/2 inch narrower. 125.00 each cheaper. -
-
-
1985 C20: Power to cab, will not start when key is in "on" position
:welcome:- Mr Clean
- Post #8
- Forum: Introduction
-
What have you done to your square lately??
On the test drive I put it in sport mode. When the turbo spooled up. Dang. I hit 125. So quite on the inside. It truly impressed me. -
-
What new tools have you got lately?
I smoked my old cordless drill a couple of weeks ago. It still works, but has no where near the power it use too. So I replaced it today.
