-
-
ZZelph replied to the thread Busted rear shock mount.Since forever. It’s the vapors that burn. I would do the suggestion above with welding it. Use a support washer like this...
-
ZYep, '47-55 was Advanced Design, '55-59 was Task Force, '60-66 was just C/K (1st gen), '67-72 was Action Line, '73-87 was Rounded Line...
-
ZZelph replied to the thread Is this a square body?.Anything is a ***** if you’re brave enough
-
ZZelph replied to the thread Is this a square body?.No. That is a deuce and a half.
-
ZI ended up buying a standard 73-87 dually bed.
-
ZZelph replied to the thread Custom drive shaft..Courtesy of Tom Woods Driveline https://cdn.shopify.com/s/files/1/0266/9871/1137/files/measuring_guide_without_logo_photos.pdf?1908...
-
ZYou mentioned that the steering box is new. Si the lash set properly? I set one up too tight once and the car was impossible to drive...
-
ZI've just got some Amazon special LED bulbs in my stock parking lights. Wired in a 50ohm resistor and they work fine. My whole truck is LED
-
ZI actually remeasured and its pretty damn close to stock, i will post results once its installed in the next several weeks to hopefully...
-
ZDon't forget the leaf springs are what keep the axle in position. If you have a broken center pin, or worn bushings at either end of...
-
ZWhat What else can they adjust on a straight axle ?
-
ZJust save yourself the trouble and buy the tool set. They are like $20 on amazon. You should have a front, rear, and pan tool. Bolt the...
-
ZI JUST did this on my daily's 5.3 (2005 LM7, same thing). I've done them in the past but I bought a book about rebuilding an LS because...
-
ZZelph replied to the thread Front suspension mystery drone.Are you lifted or stock height? Mud tires or all terrains? Your truck should have an np208, part time transfer case. Have you tried...
-
ZI wouldn't pay anything for it. Too much work, and it's not 4 wheel drive! :p
-
-
Loading…
-
Loading…
