After looking into this I notice it burnt up my new circuit board right where the bolt meter is. Was I supposed to only use two clips for two posts instead of all three? Would that caused circuit board to burn? Or do you think I have a wire problem? Where does the wire go what color and does...
Install all new gauges and cluster volt guage it working looking ito issue it burnt up my new circuit board was I supposed to use all 3 posts on back and clips for circuit board or only 2 and if only two which ones and could this been what messed it up? If not what wire in bulk head do I need to...
Can you send me pictures of how you got it connected to sniper? And can you send me a link to the fitting you got for the hard line to braided to tank and to sniper thanks
Looking for a fuel line kit preferably steel from the tank all the way to the Holley sniper 2? What have y’all done and used to hook up here’s the tank set up I’m getting
I now have a tilt wheel with wiper switch on it can I get a dash bezel without a wiper switch on the dash to delete hole will the head light switch line up?