Ricko1966's latest activity
-
RRicko1966 replied to the thread Radiator fan and shroud.Did it have transfer case braces under the motor mounts that got left out. Did you change any mounts including transfer case transmission?
-
RRicko1966 replied to the thread Quadrajet Idle Mixing Screws.Is the carbureator on or off the car? Off the car, clean and dry I'd try hitting it with propane. On the car I'd use a soldering iron to...
-
RWife got me an early Fathers Day tool, a topside creeper to reach those hard to get to places. Will be great when I need to install my...
-
RRicko1966 replied to the thread Overheating Rebuilt 350.I'd finish breaking it in, no thermostat. That was a good observation on @Bennyt s part.
-
RAs Bennyt pointed out, I have the wrong fan. I’m guessing address that first and try again? Would it still be a good idea to remove...
-
RYou’re correct, I have the stock standard rotation fan, which is wrong for serpentine setup. I need a reverse rotation fan. Good looking...
-
RStock fan? New stock Reverse rotation fan or original rotation? After looking at our serpentine trucks, looks like you might have the...
-
RRicko1966 reacted to Bextreme04's post in the thread Installed new tachometer and put a 70s fuel gauge in 85 cluster and now truck won’t start any ideas? with
Like.
Tach in a square will have a separate harness with power/ground connections and a single wire that runs from signal on the tach to the... -
RRicko1966 replied to the thread Unusual way to bleed brakes. Just might help someone..Not a fan of gravity bleeding. But using the caliper instead of the master for the pressure source worked and was convenient.
-
RRicko1966 replied to the thread Installed new tachometer and put a 70s fuel gauge in 85 cluster and now truck won’t start any ideas?.Disconnect the tach see if it starts. The tach is probably killing ignition pulse.
-
RRicko1966 replied to the thread Unusual way to bleed brakes. Just might help someone..Worked like a champ.
-
RRicko1966 reacted to Keith Seymore's post in the thread Unusual way to bleed brakes. Just might help someone. with Like.
Yes - I have done that when replacing master cylinders at the racetrack. I figure the "bubble" is right there at the master/line joint...
-
RStart here: 1975 wiring diagrams If you have no incoming power check the fusible links.
-
RRicko1966 reacted to xm20k's post in the thread Unusual way to bleed brakes. Just might help someone. with Like.
I don't see why it wouldn't, you basicly just swaped what's applying the pressure to force out the air. Pump the pedal to push air into...
-
RRicko1966 replied to the thread Unusual way to bleed brakes. Just might help someone..Makes perfect sense to me piston extended,air and fluid in the chamber in the caliper. Compress the caliper to push the air and fluid...
