Recent content by Oldsarge29
-
O
90 TBI into 85 K10 gauges
The truck is running great. This was my 1st conversion so it was a little challenging. I finally got all of the bugs worked out. The only issue was placement of the ecm. I ended up putting it on the right fender well. I just couldn’t get it to fit behind the glove box. Hopefully it will be good...- Oldsarge29
- Post #10
- Forum: TBI & EFI Conversions
-
O
90 TBI into 85 K10 gauges
I finally got it figured out. My truck had cruise control and there was an output on the module that I was able to use for the ecm. Thanks again for your help- Oldsarge29
- Post #8
- Forum: TBI & EFI Conversions
-
O
90 TBI into 85 K10 gauges
Bump. Anybody have any information??- Oldsarge29
- Post #6
- Forum: TBI & EFI Conversions
-
O
90 TBI into 85 K10 gauges
I have almost everything connected. I’m waiting on the fuel tank to get here but I did get the engine to fire off by pouring some gas into the throttle body. So, I think I have that part of the wiring done. I pulled the hard gas lines from the donor (long bed) truck and have them in the 85. When...- Oldsarge29
- Post #5
- Forum: TBI & EFI Conversions
-
O
90 TBI into 85 K10 gauges
Ok, I’ve finally got the right wiring diagrams. Everything makes sense now. The wiring is not going to be that bad. I’ll be searching for the VSS signal in the next few days. Hopefully it won’t be too hard to find. Thanks again for your help.- Oldsarge29
- Post #4
- Forum: TBI & EFI Conversions
-
O
90 TBI into 85 K10 gauges
Thanks for the information. I found the wiring diagrams and printed them out. That will help. Yes, I’m using the 85 interior harness. It’s in good condition so I’m keeping it. I’m keeping the 700r4. I didn’t want to go through the trouble of converting the th400 to 4wd. The truck has cruise...- Oldsarge29
- Post #3
- Forum: TBI & EFI Conversions
-
O
90 TBI into 85 K10 gauges
Hey all, I’m doing my first tbi swap. I have a complete donor 90 c2500 and I have pulled the engine and the wiring for the engine and dash. I have finally got the engine in the 85 and now working on the wiring. I’m not n process of connecting everything. I want to keep my current gauges working...- Oldsarge29
- Thread
- Replies: 9
- Forum: TBI & EFI Conversions
