Recent content by MrYams
-
Fuel in intake but not getting into cylinders
Any resolution to this? Same problem.- MrYams
- Post #18
- Forum: Carb Fuel Systems
-
Emissions Delete
My choke light is on constantly these days. I’ll check all of that. Closing the choke seems to make it better because it’s idling so high but no noticeable difference until your very close to killing the engine.- MrYams
- Post #3
- Forum: Tech Discussion
-
Emissions Delete
Noob looking for help. Not a mechanic just a guy who luvs squares and cussing. 1986 C10 305 Truck is running like garbage but with every vacuum line I pop off she runs a little better. The EGR has been removed and capped and I’d like to remove the air pump and anything else unnecessary for...- MrYams
- Thread
- egr emissions delete smog delete
- Replies: 4
- Forum: Tech Discussion
-
‘86 Wiper/Washer Switch Relocate
I’ve been able to find wiring diagrams and even came across a pic of the harness (included) it’s actually two connectors, coming off of what I’m guessing is the delay module. So far have had no luck finding anything telling me which pin on the back of the switch does what tho. Haven’t given up...- MrYams
- Post #5
- Forum: Retro-Fit & Aftermarket Accessories
-
‘86 Wiper/Washer Switch Relocate
I’ve pulled the column wires down into the dash at the location I would like to mount the switch. What I need help with is knowing where those column wires land on the switch….The rest of the wiring was so easy I had no idea wipers were going to kick my butt like they have.- MrYams
- Post #3
- Forum: Retro-Fit & Aftermarket Accessories
-
‘86 Wiper/Washer Switch Relocate
Relocating wiper switch column to dashboard. Wanting to use the switch from an ‘83 because they both seem to have the same functions but I don’t have an ‘83 wiring harness that plugs into the back of it. Landing the wires on the new switch isn’t a problem but figuring out what wires to pin...- MrYams
- Thread
- Replies: 10
- Forum: Retro-Fit & Aftermarket Accessories
-
Can Front Rotors/Calipers be Relocated?
I assumed you couldn’t but as I looked at conversion kits all four discs look identical and I started to question it. Hadn’t even considered the E-brake. Thanks! -
Can Front Rotors/Calipers be Relocated?
Apologies in advance if this is dumb question of the day. I know enough to get by and be dangerous… I would like to put larger rotors/calipers on the front of my ‘86 C10 and if possible move the OM rotors/calipers (1”) to the rear replacing the drums. Will stock front disc brakes fit on the rear?
