Recent content by Kelly Mac

  1. K

    RECOVERED AFTER STOLEN..HOW TO PREVENT THIS AGAIN

    I have a hidden foot switch on the starter circuit, also another hidden switch in series with it for when im out of town. Also try and make a hood lock, so they cant pop the hood and wire it that way. Most thieves of this truck are young thugs, they wont spend time trying start it other than the...
  2. K

    RECOVERED AFTER STOLEN..HOW TO PREVENT THIS AGAIN

  3. K

    Alan grove brackets

    I'm using the V-belt type. I guess no one else is using this set up. Im really happy with it, used a Sanden type compressor and made my own AC lines, it works really well with stock condenser, evaporator and dryer. The belt length seems a little long. I will keep up the research.
  4. K

    Alan grove brackets

  5. K

    Alan grove brackets

    AC, what was I thinking? Stay's warm in GA.
  6. K

    Alan grove brackets

    I'm using Alan Grove brackets for my Sanden compressor and power steering pump. They are a great product and i'm very pleased with them. My question is, has anyone using these brackets incorporated a idler pulley for the AC compressor belt? If so, what did you use? Thanks
  7. K

    Relay, power door locks

    Hey, any good replacement relays for the power door locks? Mine is bad and i would lime to replace it. I'm sure with a lot of research i could find a late model one and wire it in. Any ideas? Thanks
  8. K

    Low air flow through dash vents.

    Thanks, my plastic is new but the plastic door connected to it via a metal rod, seems to be broken. It was blocking the metal door from opening up and letting the AC air through the dash vents. I'm looking around for another heater/ac box to see if my door really is broken. Also, on max AC my...
  9. K

    86 front suspension

    Thanks, i will set it too the -1/4 and see how it does.
  10. K

    86 front suspension

    No autocross, just street. I have c10 short wheel base 86. 800lb springs aftermarket large sway bar. Just wondering what camber setting your using if not stock setting. Thanks
  11. K

    86 front suspension

    Working on my front suspension this week, new ball joints, bushings and springs. Damn what a job. Any of yall use different alignment settings then the factory? My truck is stock height but i still want it to handle, not to worried about tire wear. How much negative camber are you using? Thanks
  12. K

    Low air flow through dash vents.

    I have a 86 C10, with factory AC. I have been working on getting the AC and Heat to work correctly, this forum has been lots of help. So thanks. My dash vents dont blow enough air. This includes the two on the passenger side and the one in the gauge bezel. My AC blows cold with real good flow...
  13. K

    New shocks

    Installed 4 new bilstein shocks on my 86 C-10 today. Replaced some worn out Monroe Sensatrac's with the Bilsteins. Ride and handling improved greatly.
  14. K

    aftermarket efi

    Not sure if I would go with the TBI or port injection. I'm working toward making my 86 a daily driver for my 70 mile round trip. My plan is to rebuild the suspension and then install a TKO transmission and maybe then the fuel injection. I thought about the 5.3 engine swap but my current engine...
  15. K

    aftermarket efi

    Is anyone running a self learning efi? ie msd atomic, holley efi?
See more

Latest posts

Forum statistics

Threads
42,204
Posts
911,289
Members
33,700
Latest member
Taco main chew
Top