K5 Blazer
Latest activity Postings About
-
-
K5 Blazer replied to the thread What’s the best way to fix/clean up this wiring problem?.I would using a Blue Seas SafetyHub. Chase down each wire and try to determine the amperage draw and install the appropriate fuse. This... -
Typically the enclosure is what makes a speaker.
-
K5 Blazer replied to the thread Kick panel Speaker Mounts.My stereo does have an amp and I will install a sub but there is some bass that comes thru the speakers as well. These speakers were not...
-
Installed a pair of kick panel speakers and they sound like crap. I don't think it's the speakers, I think it's the panels and the tiny...
-
-
K5 Blazer replied to the thread Engine oil lines..I am in the camp that the oil cooler is overkill unless you plan on doing heavy hauling. I did an LS swap on my blazer and deleted the...
-
I was seeing if anyone else has had this issue and have they done anything about it? My 1973 Blazer door strikers are starting to crack...
-
-
K5 Blazer replied to the thread What gears.I have a 1973 Blazer with a LS swap and 4L60E tranny, 4" lift with 33" tires. I changed the gear ratio to 4.56. I think for my set-up...
-
K5 Blazer reacted to Zelph's post in the thread 1973 Blazer tailgate aluminum panel restoration with
Like.
I would hit up a hot rod shop or custom car shops and see about having them repair any dents or straightening and maybe do the... -
K5 Blazer replied to the thread 1973 Blazer tailgate aluminum panel restoration.Did you have any luck on restoring your tailgate band? In the same situation with the same vehicle.
-
I have a 1973 K5 Blazer and trying to replace the tailgate trim band. Unfortunately, I have not been able to find a clean oem or...
-
-
K5 Blazer reacted to TDoc's post in the thread K5 K10 17x8 or 17x9 vision Cheyenne Aluminum rally wheels? with Like.
Even with my extended lugnuts, is this as simple as measuring 7/16 from end of wheel stud, mark it. Count the turns until I hit that...
-
I just purchased a new factory grille for my K10. LMC $258.50 shipped - before tax Holley $65.81 shipped before tax ~ 75% off.
-
K5 Blazer reacted to SierraClassique's post in the thread What have you done to your square lately?? with Like.
Replaced the 40 year old trash bag + decaying insulation mess on the rear interior panels with a self-adhesive, closed cell foam. And...
-
I like the appearance of your gauges! Gives a 1973-1979 appearance
-
K5 Blazer replied to the thread NP241-C, non VSS. Can I convert to VSS or no. No luck!!.I am using the holley terminator max. I don't think there is any provision to control the VSS signal.
-
-
Loading…
-
Loading…
