Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
Registered members
Current visitors
Menu
Log in
Register
Install the app
Install
Members
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
GTX63's latest activity
GTX63
replied to the thread
Want to build a good horsepower, good fuel economy engine for a 1978 c20 with stock 350. I don't know much and need help.
.
Welcome Quinn. Vortec heads are a nice addition to a gen 1 small block chevy, just make sure you have used heads checked as they are...
Feb 29, 2024
GTX63
replied to the thread
86 c10-silverado
.
Welcome to the forum. That 350 didn't begin it's life in a 1965 Impala, so you might want to make note of the numbers on the rear driver...
Feb 28, 2024
GTX63
replied to the thread
Interesting Oil Pressure Indications
.
You can use a mechanical gauge to confirm what your oil pressure is. Are you saying that before the gauge failed the pressure was lower...
Feb 28, 2024
GTX63
replied to the thread
Carb Swap?
.
As a young kid in 1984, I bought a 1965 Chevy Caprice off the original owners. They had seen the car inside a Chevrolet dealership...
Feb 27, 2024
GTX63
replied to the thread
Carb Swap?
.
The Qjet was the factory go to 4 barrel on GMs for 20+ years for a reason. Believe it or not, brand new they used to start with little...
Feb 27, 2024
GTX63
replied to the thread
Oil pressure sending unit on manifold 305
.
That is the OE wire and factory boot on one of my k10s. The wire comes thru the bulkhead connector and into a loom. The video below...
Feb 26, 2024
GTX63
replied to the thread
New from Tennessee..
.
Welcome from Fentress County, Tennessee.
Feb 26, 2024
GTX63
replied to the thread
Spray vs Plastic Bedliner
.
I've used both the DIY bed liner and had one sprayed. My opinion is that if your aim is to build a high end truck, don't do it. Don't...
Feb 21, 2024
GTX63
replied to the thread
Rear end gear ratio change or transmission change ?
.
If you cannot get on the freeway, then without you giving us your current gear ratio, we would have to assume you are spinning 5K @...
Feb 20, 2024
Latest posts
Engine Stalling - Bad EVAP/Charcoal Canister?
Latest: Radiohead
27 minutes ago
Carb Fuel Systems
What have you done to your square lately??
Latest: pinballlarry1
30 minutes ago
Garage
R
Finding the Correct Vacuum Balance
Latest: Ricko1966
Today at 4:50 PM
Engine & Performance
R
Engine died when driving and won't start - Coil melted
Latest: Ricko1966
Today at 4:35 PM
Engine & Performance
For you LS swap guys.
Latest: Terry Wilkerson
Today at 4:08 PM
Engine Swaps (Gas) LS, Vortec, LT1 , etc.
Forum statistics
Threads
42,348
Posts
914,084
Members
33,849
Latest member
90_burb
Members
Top