Craig Nedrow's latest activity
-
^^^^^^^^^Not a lot of fixed yoke 400s behind 350 C10s?? Not sayin they don't exist......^^^^^^^^ -
If you pull the drive shaft and start the engine and put it in drive, you run the risk of pumping all your ATF out on your floor...
-
Hi - all the above is great advice, however it is very hard to provide accurate advice "remotely". From what you describe, it may be...
-
I didn't answer because I do not know enough about interchange on the rearends,to tell someone what is a straight swap. I don't believe...
-
Use a power lock controller from a newer vehicle with a key fob.
-
Craig Nedrow replied to the thread Dump trailer opinions.Texas Pride, direct from mfg to you, also Montana is cute as a bugs ear. Link: I gonna get me one!
-
That would probably help! The door side lip of the weatherstripping is below the top edge of the door, is it supposed to sit on top...
-
Egr is fine, did get sold a bad injector put old injector in left side thing runs brand new again. Moral of story as usual check ur...
-
Been messing around with her this morning right injector good spray working good, left injector absolutely zero spray and then drips...
-
Check for steady vacuum then compression after EGR as suggested. Most times the pintle in EGR can be raised with a finger. If no...
-
HAve you replaced the EGR? It has a rubber diaphragm in it that can crack/break and leak Or, there might be a carbon deposit in the...
-
Craig Nedrow reacted to Phillippio's post in the thread I am joining the club with a new to me 1977 GMC C15 with
Like.
Hello All, I just picked up a neglected forgotten 1977 GMC C15 Square Body Sierra Classic. This is an Arizona Truck so very little... -
Craig Nedrow replied to the thread What year bed is this.That's odd, because I have two 73's a K10, and a K20, both have the doors, and both are original.
-
Was thinking of redoing mine myself, but decided to go with this one. Took a couple of hours and putting it in and out half a dozen...
-
When I was searching for new dash pads I ran across an article where someone took a metal core like that and put a dash overlay right on...
