Chris64's latest activity
-
I need to address the leaky elephant in the room. Luckily the only place my truck leaking (making it to the ground anyway) is the... -
You aren't supposed to start adjusting the box with the sector lash adjuster. You are supposed to set the worm gear thrust from the...
-
Chris64 replied to the thread V2500 4in lift replacement? ORD?.I dug into this a little tonight. I tightened the adjuster 1/4 turn at a time until the steering started to be a little resistant and...
-
Yeah, it has a BIT of bump steer, but hardly noticeable. That I can manage. Some of it's wandering, at least at freeway speeds, is those...
-
Chris64 replied to the thread V2500 4in lift replacement? ORD?.I wonder the same thing. It becomes costly by the time you get the 2wd steering box and either a new machined knuckle or find someone...
-
Chris64 replied to the thread What have you done to your square lately??.I tried to find a good thread on best practices to remove the resistor wire and replace it in the wire harness etc but I need a tach...
-
Chris64 reacted to legopnuematic's post in the thread What have you done to your square lately?? with
Like.
On a 1973-1974 (or 1975 with Electronic ignition delete, so points) they use a resistor wire that with key on drops the voltage to ~7-9... -
Sorry, I don't normally get on the computer during weekends. As mentioned, I would upgrade it as well.
-
Is the system completely empty? If it still has a partial charge, you can rest assured the system doesn’t have a major component...
-
I was faced with the same dilemma. Chose to replace everything. Bought the larges condensor I could find, replaced evaporator and...
-
Chris64 replied to the thread What have you done to your square lately??.:oops: I sure did...err...tonight. So that line going to the coil isn't 12v? TIL.
-
Chris64 replied to the thread What have you done to your square lately??.Finally switched to an HEI system. I bought new cables (unfinished so I could make them the exact length) but they didn't fit the new...
-
Chris64 reacted to Tank6x2's post in the thread What have you done to your square lately?? with Wow.
Outer Roof panel primed, sound deadened both to replace what was there originally and have a touch of sound proofing, the AMD panel...
-
Chris64 reacted to TotalyHucked's post in the thread What have you done to your square lately?? with Like.
Nothing fancy, warshed it. It was NASTY, don’t think it’s been washed in like 5500mi/4-5mo
-
Chris64 reacted to PrairieDrifter's post in the thread What have you done to your square lately?? with Like.
I switched to a Holley and immediately got an Afr gauge, it has been a big help. Then I got a vacuum gauge too and that just ties the...
