Broken85's latest activity
-
Turbo looking at your reverb from the 4 pin connector side it connects like this: If you want to bypass the transducer (reverb spring)... -
A lot of good information! Once more though, PAG oil is a corrosive and should NOT be used in a retro-fit system. Ester oil should be...
-
Broken85 replied to the thread Hi, I’m new here.Truth. My short bed rights only slightly better than my Massey Fergusson 245.
-
You are correct, found it a diagram:
-
Could be wrong, orifice tube in front and an expansion valve in the rear
-
Broken85 replied to the thread 700R4 Information Thread.Thanks for these suggestions Nick. I have tried to adjust the TV cable to bring this up. Park/Neutral/Drive/3rd and Reverse pressures...
-
There seems to be a leak in the manual low circuit as 110 PSI is too low if that reading is at full TV, per my guide. Ask the trans...
-
Broken85 replied to the thread 700R4 Information Thread.Nick, I recently got the 700R4 from my 85 K10 rebuilt. Transmission is installed and before I moved it, I pressure tested the trans per...
-
Broken85 replied to the thread 700R4 manual low and manual 2nd low pressure.It is actually a good question, should have included that. I am using Dexteon VI. The tech said standard fluid is fine (not that he is...
-
-
Broken85 posted the thread 700R4 manual low and manual 2nd low pressure in Transmission & Transfer Case.I recently got a 700R4 from my 85 K10 rebuilt. Bolted to a 375hp small block with a sniper. Transmission is installed and before I...
-
Broken85 replied to the thread Source for rear AC fittings?.There is no expansion valve. They use an orifis tube. https://www.amazon.com/dp/B000C9C8EK/
-
Broken85 replied to the thread Hydroboost not working.Drain the system and start with new fluid. If you don't bleed it right to start with, air will mix with the fluid and you will never...
-
i am curious why not to many people had seen that.....with 5,000,000 trucks made.....
-
i agree the "hooks" point down and forward and when original probably swung better than they do now, the inertia would be correct...
-
Broken85 replied to the thread Seat frame Question......I only know that is what it is because I also did a reupholster of my seat and had the same mechanism on my 85 Silverado K10 and I...
