Recent content by Brandon_l1000
-
B
Speedo
So, I just picked up a 1990 suburban for 500 bucks. The speedometer doesn't work, does that work off of a speed sensor? If so are there any tips to changing it? I believe it's a 4l60e but I could be wrong. All of my other trucks are manual, so I dont have any experience with older automatic...- Brandon_l1000
- Thread
- Replies: 1
- Forum: Transmission & Transfer Case
-
B
Carb replacement
Hey, I'm replacing my quadrajet with an edlebrock on my 79 350. However, I have ran into a problem. My engine has a bracket that is held down by the two rear carb bolts. The bracket hold my throttle cable. The bracket wont fit on the new carb because the spacer uses the holes. Anybody had this...- Brandon_l1000
- Thread
- Replies: 1
- Forum: Engine & Performance
-
B
tools for sale
not sure if this is the right place for this, but i have some specialty tools to sale. I have a steering wheel puller, ball joint press, strut compressors, adapter for honda ball joints, and rear brake caliper compressor. If you are interested message me and we can work out a price.- Brandon_l1000
- Thread
- Replies: 2
- Forum: For Sale
-
B
gas guage help
I went thru this same thing with mine. I had to completely re wire mine and just run the wire to the back of the guage, because the circuit board, if you can call it a board, was bad- Brandon_l1000
- Post #7
- Forum: Tech Discussion
-
B
quick question
piece of **** is right man but she got it for 700 bucks so I cant complain to much lmao it would be a good car if I could figure out what the hell its problem is lmao- Brandon_l1000
- Post #6
- Forum: Other Vehicles
-
B
quick question
yea I changed the idle air, the mass air flow, I have put new plenum gaskets on it, I have been over it with a fine tooth comb looking for vacuum leaks, I have compression tested the cylinders, changed spark plugs, changed the fuel injectors, checked the fuel pressure regulator, checked all the...- Brandon_l1000
- Post #4
- Forum: Other Vehicles
-
B
quick question
hey fella I am working on the old ladies car it is a 99 Honda passport. It has a miss that I have been trying to fix for only god know how long. I even took it to a mechanic and he couldn't figure it out. when it is idling it will rev up and down. sometimes to point that it dies. I also noticed...- Brandon_l1000
- Thread
- Replies: 7
- Forum: Other Vehicles
-
B
Need a solid opinion
I would go black interior, I have never been a fan of red interior.- Brandon_l1000
- Post #12
- Forum: Interior
-
B
Got a van
man we use the newer chevy vans at work and we put the miles on them. we had one with 450 mileson it before we traded it in.- Brandon_l1000
- Post #3
- Forum: Other Vehicles
-
B
oil pressure
the wiring was the first thing I thought about I haven't had a chance to check it yet tho.- Brandon_l1000
- Post #3
- Forum: Engine & Performance
-
B
oil pressure
hey fella took the old girl to get some lumber yesterday. on my way back the oil pressure gauge started going stupid it usually stays on about 30. well it would shoot up to 60 then back to thirty to half way and then back to thirty then up to 60 again, and on an on. all the way to the house. you...- Brandon_l1000
- Thread
- Replies: 3
- Forum: Engine & Performance
-
B
Constant power for new radio?
yea I had to completely rewire mine too lmao- Brandon_l1000
- Post #3
- Forum: Stereo & Entertainment Systems
-
B
Debadging?
I toyed with this idea. my emblems are shoot so my deciding factor was the damn cost of the things i refuse to pay that much just for badges. so im leaving mine off. I mean the scottsdale emblem for mine is 50 dollars to me that is ridiculous as hell- Brandon_l1000
- Post #6
- Forum: Exterior
-
B
How to take OUT of 4WD
man to get mine out you have to pull forward about 15 feet the back up about 5 then it will come out. lol they can be a bitch sometimes lol- Brandon_l1000
- Post #8
- Forum: Transfer Case
