BadBowtie's latest activity
-
1987 Chevy v10 on 2 inch lift rear blocks, all front end components new. Steering box is new with weld on brace and bolt on brace, XJ... -
I remember that now, thank you. I think the bottom left hole may be for that as well.
-
The one under the large hole for the blower motor wiring is for the jute insulation, for a push in rubber retainer
-
Based on the title, I was half expecting to see a risqué picture of his new girlfriend.
-
That seems pretty asinine to me as well. :boxed: I'll have to remember to NOT use Energy Suspension bushings.
-
I am about to replace my timing chain too. Mine is on a 7.4L but it is the same design. As was said above, turn the engine until the...
-
I'm in the middle of a water pump replacement on my stock 305 for my 84 k10. This led to a timing cover gasket change to fix an oil...
-
I'd clean it up and paint it with a really tough paint. Then put it back where it belongs. Better to have it and never need it, than to...
-
You have to figure out what to do with it ??
-
Next step would be to take some good pictures of it with a neutral background. Then upload those images into "Google image search" and...
-
Great idea. I checked and I cant find any stampings anywhere.
-
Any part numbers stamped on it anywhere?
-
Do you have the phone number of the person or business that you bought the rig from? Perhaps they could provide some insight.
-
Hmm. A strange curved metal pate of some sort.. Did you find it under the drivers seat, or inside the fuel tank?
-
Since this is a new to me vehicle I have taken it to be serviced top to bottom, front to back, however on the way to the shop it was...
