84_c10_GMC's latest activity
-
84_c10_GMC reacted to Ricko1966's post in the thread Another response to ***CAUTION, PLEASE READ *** with
Like.
It wasn't aimed at you,but for all we know you are a risk. Bad guys don't tell you they are bad guys. Also you're going to need thicker... -
84_c10_GMC reacted to Grit dog's post in the thread How to switch from a DRW to a SRW in a 1981 K30 / 350 engine / 3 speed manual / 4x4 with Like.
Assume the OP is out turnin and burnin with the snowplow. Or just figured out that it’s easier to leave his truck alone and move on...
-
84_c10_GMC reacted to Ricko1966's post in the thread How to switch from a DRW to a SRW in a 1981 K30 / 350 engine / 3 speed manual / 4x4 with Haha.
It's going to look funny with 3 wheels on the back.
-
84_c10_GMC reacted to idahovette's post in the thread How to switch from a DRW to a SRW in a 1981 K30 / 350 engine / 3 speed manual / 4x4 with Like.
WHY?????
-
84_c10_GMC reacted to 82sbshortbed's post in the thread What have you done to your square lately?? with Like.
Drove the 84 to work this morning. It runs so much better now than it did before with the edelbrock carb. It runs so smooth at the light...
-
84_c10_GMC reacted to Tonimus's post in the thread What have you done to your square lately?? with Like.
Put new rollers on the window regulator, new window motor, new key switch. Next is to put relays in there, but it works again!
-
The bigger trucks typically had 350's, 366's, 427's, Cat diesels, and 4-53 Detroits, among other things.
-
84_c10_GMC reacted to Strick's post in the thread What have you done to your square lately?? with Like.
This one was posted on the web & I went & grabbed it. 76 Sierra SM465/NP205 with an excellent grille & decent tailgate. HS
-
84_c10_GMC reacted to ChuckN's post in the thread What have you done to your square lately?? with Like.
Project stall converter engage.
-
84_c10_GMC reacted to Soundmound's post in the thread What have you done to your square lately?? with Like.
In the last two weeks I have had the transmission repaired/serviced and sealed. I had the exhaust replaced from the Y back with 3" and a...
-
Thanks everyone. Yall were correct: it was a ground issue. I managed to fix that problem. It was the one loose ground wire at the...
-
You may have seen one in a Blazer, but that's not where it started life. Those fuel/tach combos were optional in the medium duty (C50...
-
It's there on the back, but the HVAC cable is obstructing it.
-
Also, one of the "outer" knobs should be tone control. That's the sound change you were talking about. If the other "outer" knob moves...
-
Below radio will fit opening without cutting and is stereo. Wiring is different so will need to adapt. Have sold about a 100 of these...
