82SquareBurb's latest activity
-
82SquareBurb reacted to HotRodPC's post in the thread 14 Bolt Full Float / Semi Float Identification with
Like.
Yes, you are right. 9.5inch ring gear in the 14B SF. The SF also uses C clips to keep the axles in. It comes in both 8 lug and 6 lug... -
82SquareBurb reacted to HotRodPC's post in the thread 14 Bolt Full Float / Semi Float Identification with Like.
For those who are not aware. Very easy to tell the difference in a 14 Bolt Full Float and a 14 Bolt Semi Float. Full Float has the axle...
-
hey Craig! The heads are their IK (iron killer) 200. 200cc runners, 64cc chamber. With the .036 head gaskets and the 12cc dished...
-
70" I believe with a TH350 mine is 72.5 due to the powerglide. Mine only came close to the cab floor directly under the seat area but a...
-
Heads are on and torqued. I checked the pushrod length and determined 7.4”. And of course the rockers aren’t sitting on the shank like...
-
82SquareBurb replied to the thread LWB driveshaft question.Very nice, love that bed liner as well. Do you recall the Cap-Cap length for the long bed? C10 Suburbans come in about 72" for the...
-
I have a 1981 C10 longbed with a factory one piece driveshaft. I replaced it with a 5" aluminum. The weight difference is unbelievable.
-
82SquareBurb replied to the thread LWB driveshaft question.Yeah it seems GM switched depending on the application. Wondering how the center carrier crossmember clears when switching from 2pc...
-
It appears from the replies c10 has one-piece, and c20 and heavier get two-piece. I have only had c20s and they all have two-piece.
-
I miss read the 2WD and 72” tube portion - I was thinking this was a 4WD application with a shorter tube dimension. My apologies, Tom
-
82SquareBurb replied to the thread LWB driveshaft question.Thanks for confirming. Looks identical to the one I have. Yeah I knew I had a problem when Mark Williams' told me to pound sand when...
-
‘80~’88 K-30’s with a regular cab and a fleetside bed SRW & DRW ran a two joint slip yoke shaft setup that was steel but only 4”...
-
85 K 10 one piece steel shaft. Was a 700R , now a 350. No problems
-
Both my 76 and 79 C10's, both LWB (and both TH350's) are factory 1pc drive shafts. The 85 C10 (305/TH350) I had parted out was also a...
-
Mine is an aluminum 5" at 72.5" center to center but that's because no one would build a steel one longer than 60" for over 500HP. Best...
