Search results
-
W
Ashtray cup holder design
Have you seen the one built by Brothers Truck Parts? Very similar design. https://www.brotherstrucks.com/73-87-ASH-TRAY-CUP-HOLDER/productinfo/ATC7387/- Wyomingite
- Post #9
- Forum: Interior
-
W
Guess The Tool
I have no idea what this one is. Was in my Dads old toolbox.- Wyomingite
- Post #60
- Forum: Garage
-
W
Inner Fender Replacements
Yeah the brace is where the rust has started. Other than that they are in fine shape- Wyomingite
- Post #6
- Forum: Exterior
-
W
Inner Fender Replacements
Yep in Wyoming. Not much resource here for parts!- Wyomingite
- Post #4
- Forum: Exterior
-
W
Inner Fender Replacements
Looking to buy some new inner fenders for my 86. Looks like the OEM have been discontinued online anyway, I haven't called the dealer to verify. So l see some on Amazon, Jegs, Summit for about $50-$70 with shipping. And then some on LMC and Brothers for about $200 with shipping. Is there much of...- Wyomingite
- Thread
- Replies: 5
- Forum: Exterior
-
W
Looking for info on dealer installed air
Just went through this myself. I also have a dealer installed system and recently got some info on it. Found the company that originally built these systems and was able to contact them. Sounds like they have moved more into the export side of things since then but the gentlemen I talked to...- Wyomingite
- Post #11
- Forum: Heat & AC
-
W
Looking for oddball crank pulley
Not sure. Ill have to look when I get home....I want to say it is made by York- Wyomingite
- Post #7
- Forum: Engine & Performance
-
W
Looking for oddball crank pulley
ok that make sense. Maybe the 3 groove will work then. What is the outer pump pulley groove to? Smog pump? And anything at all on the inner most crank groove?- Wyomingite
- Post #5
- Forum: Engine & Performance
-
W
Looking for oddball crank pulley
Not Factory A/C. Had a dealer installed system when new. I always believed that was ran off the front groove of the water pump pulley? I have seen several crank pulleys with 2 v's and a serpentine.....would that work? Wasn't sure on the spacing of the grooves for alignment- Wyomingite
- Post #3
- Forum: Engine & Performance
-
W
Looking for oddball crank pulley
I am in search of a crank pulley for my 86 K10 and not having much luck. It is the single V for the power steering and then serpentine for water pump and alternator. Looks like GM has discontinued making these and I cant even locate a used one. I realize I can swap the whole pulley setup, but...- Wyomingite
- Thread
- Replies: 7
- Forum: Engine & Performance
