I'll call my guy that programmed my ecu and see if he can do something like that. Something when I reach wot that it sends a signal to that switch.
Sent from my SM-G960U using Tapatalk
Hi everyone.
So I ls swapped my 87 c20 to a lm7 5.3 out of an 04 Avalanche. I didn't take the trans because it was a 4x4. Everything is done. (Except this) Does anyone have a solution for the kick down (passing gear) on a drive by wire setup?
I appreciate your time.
Sent from my SM-G960U using...
I have a question about the swap. I did the kit swap with the longer tail shaft. Everything fits perfectly. Only issue I have is I think the torque converter is too small. What size TC would be used for a 85 k10 suburban in a th350? My truck seems to be missing power after the swap. Almost like...
Ok, I have a 85 K10 Suburban. I'm looking for rims from newer trucks that will fit. What's out there that will transfer and fit? Is there anything?
Sent from my SM-G930V using Tapatalk
Make sure you get the continuous duty relays. Starter relay will burn out. I learned the hard way with adding a battery.
Sent from my SM-G930V using Tapatalk
Ok, so from what I'm getting from this thread is.....
Hi and low will both run off of 2 separate 40 amp relays. Correct? I'd rather over do it than blow relays. Secondly, what would you use for a controller? I would like to utilize both fans on temp switches with a override on for the a/c or...