-
-
On the newer stuff, you're right, they are much smarter and you gain a lot of flexibility. The earlier returnless was more what I was... -
It is sort of a trade off cycle. Pump mounted external makes it easier to mess with wiring and/or change out, but it also makes it more...
-
as much as I hate to say, I wish I had installed an external fuel pump. This way in the future, when in doubt you can get to it easier...
-
KennedyHill replied to the thread LS swap fuel system.Thanks for the advice! After doing a bit more investigation, most people say the factory regulator is the way to go! Good to know. Thank...
-
Yes, run the factory regulator on the rail. Most people think that the "returnless" style is better because it is newer, it isn't. It...
-
I am currently working on a 5.3 LS swap in my squarebody. I have a question on the fuel system. I think I have what is called the “truck...
-
Lube with soapy water or silicone spray and get it started with a flat blade screw driver on one end and and then it should slide in. If...
-
Does anyone have suggestions on how to install the bump stops on lower control arms? I don’t want to say I’ve tried everything, but I’ve...
-
If they’re not making noise, then it’s fine. Plenty of leaf setups with no plastic shims
-
I am reconditioning my leaf springs. Plastic shims (I don’t know what else to call them) came off the ends of the leaf springs. It looks...
-
Check camber before taking it apart,shim it on reassembly to make camber match. Stagger the thicker shims and thinner shims front to...
-
I’m rebuilding the suspension on my ‘87. I’ve put new bushings and ball joints in the lower control arms, but I’m replacing the upper...
-
-
Loading…
-
Loading…
