Recent content by fullbore
-
TH400 Problem
Thanks HotRodPC.....figured that what was going to be needed next.- fullbore
- Post #3
- Forum: Automatic Transmission
-
TH400 Problem
Hello all!! Hope someone has had this same problem. I have a th400 that as you put it into drive ans start to move when it starts to upshift to 2nd bounces right back into 1st. Then if I hold the peddle there it will go back and fourth untill i stomp on it or let off. The rpm climbs hi then...- fullbore
- Thread
- Replies: 14
- Forum: Automatic Transmission
-
NO POWER...NEED HELP
Hello all, Anyone have any suggestions?- fullbore
- Post #3
- Forum: Engine & Performance
-
another new guy here
Dang it...my bad just was going to the wrong page looking for that box. THANKS Honky Kong JR!!!!- fullbore
- Post #24
- Forum: Introduction
-
another new guy here
It has the box in site news and introduction but that is it- fullbore
- Post #23
- Forum: Introduction
-
NO POWER...NEED HELP
hello all, I have a 84 K20 that has just stopped. All power is gone. Things I have done so far Checked all fusable links checked all fuses made sure battery had power...lol this is where it gets weird Checked for power at 2 red wires at the ignition incoming power at the light switch droped...- fullbore
- Thread
- Replies: 6
- Forum: Engine & Performance
-
-
another new guy here
Do you think I need to talk to the moderator? The new post box isnt there- fullbore
- Post #19
- Forum: Introduction
-
another new guy here
Yea thats what I did here in the introduction forum however in the others that box does not show up???- fullbore
- Post #14
- Forum: Introduction
-
another new guy here
hey Big Chip....Im just trying to post a question in the electrical forum. i got a problem and wanted to see if anyone out there has had the same.- fullbore
- Post #9
- Forum: Introduction
-
another new guy here
Thanks Guys! When I get into the forum id like to post into there is no " new post" or button to click to do it.- fullbore
- Post #4
- Forum: Introduction
-
another new guy here
Mike from WA state. Owner of Fullbore Machine and Fab and two squares. One a 83 k20 the other , my sons project 84 k20. Can anyone tell me how to start a new post? thanks!- fullbore
- Thread
- Replies: 27
- Forum: Introduction
-
208 poping
When I engage 4wheel low or high and let it idle forward the truck surges and makes a pop thumping sound. So I jumped out with the truck rolling and could see the t case in one corner pulling away every rotation. Must be a broke gear or bent shaft in the t case...- fullbore
- Post #3
- Forum: Transmission & Transfer Case
-
208 poping
208 popping Hello, anyone ever had their np208 pop and bounce away from the trany while in 4wd? I noticed a loose nut tightened it up but it still does it....Any suggestions? Thanks Full bore- fullbore
- Thread
- Replies: 5
- Forum: Transmission & Transfer Case
