Had the new wheels put on today at tire shop with conventional lug nuts. Truck rode like a worn out wagon! Going to Summit Racing tomorrow to talk with reps there and purchase the correct Cragar lug nuts. Cragars are 610G SS with correct 5 on 5 bolt pattern, +00 offset. Lug needs a shank to...
Can you get a needle nose vice grip on the screw head? If so, you can apply pulling pressure while you spin the screw out.
Don't forget about the salvage yards in a grille replacement too to save some $.
I also bought one from LMC and it seemed short too. Here's what I did to make it fit: placed hose in direct sunlight for several hrs to help soften it up, then pulled to stretch hose overall.
I secured end at front with a worm gear clamp and used a long zip tie at breather end. You could also...
My truck was missing this long duct so I purchased one from LMC. I just got the AC serviced and sealed the ducts today with foam tape. This long duct to left vent is the last piece to get the ducting installed correctly. I'll give it another look tomorrow. Thanks for the advice!
Can anyone explain the routing and positioning of the long duct tube that runs from HVAC box to the far left vent on driver's side? Does the dash pad need to come off to install it? Thanks.
Have an 87 GMC Sierra Classic- I do not have any blower fan blowing at any of the speed switch settings. Switch is also new. Can someone point me in the direction of what to check in order of trouble shooting? Thanks in advance.
No luck at the salvage yard this morning. I did find and purchase a 91 Caprice 16X4 compact spare off eBay though. I will take some measurements under the bed as I plan to mount a winch type mechanism for a carrier.