Tilecrew
Junior Member
- Joined
- Jun 8, 2014
- Posts
- 7
- Reaction score
- 0
- Location
- Rigby ID
- First Name
- Matt
- Truck Year
- 87 crew
- Truck Model
- V30
- Engine Size
- 350
I bought an 84 K10 that was previously a 6.2 but the entire drive train has been removed. I have a complete drive train from a 92 TBI to put in it. 350/700R4/241. I still have access to the 92 for any parts I'll need for the swap. Also it looks like rather than unhooking most wires the PO just cut them.
So that being said where to start? Will the harness out of the 92 fit? Or would a painless be better? Inside the cab looks intact so would only need the engine harness.
Also what other issues will I run into? Fuel pump, tanks, lines, o2 sensors are a few I've seen mentioned around here. Anything I've missed?
So that being said where to start? Will the harness out of the 92 fit? Or would a painless be better? Inside the cab looks intact so would only need the engine harness.
Also what other issues will I run into? Fuel pump, tanks, lines, o2 sensors are a few I've seen mentioned around here. Anything I've missed?