New member from Moncton looking for Help on lifted setup

[76Chevyproject]

I have a k10 with a dana 60 in the front with a 4speed standard and a np 205 tcase i bought the truck in pieces i am just looking for knowledge on how my pinion angle should be sitting and what lenght my front shaft is going to be roughly and what angles are exceptable on the shaft

 

[Old77]

 

[Arkansas_V8]

Welcome aboard.

https://www.fourwheeler.com/how-to/...ry-understanding-pinion-and-driveshaft-angle/

 

[Shorty81]

Welcome from the Buckeye State.

 

[WFO]

Welcome from the Texas Panhandle.

 

[animal]

 

[Termite_Delight]

Welcome from the Ottawa Valley

 

[RoryH19]

Welcome from TX

 

[Craig 85]

Welcome. What your plans with the truck? My past 2 trucks have had Tuff Country lifts. Their springs don't require tapered wedges in the front end like the old Rancho stuff did. On my K30, I believe I had to add an inch or less to my front drive shaft. I got lucky and had to replace the slip yoke which was available in a longer length, so I didn't have to add tubing. This drive shaft is for a 205 with a TH-400.

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

 

[1973c10]

Welcome

 

[Doppleganger]

You must be registered for see images attach

 

[dvdswan]

Welcome to the site.