Search results

  1. C

    For Sale

    Found this on Columbia, Missouri Craigslist! https://columbiamo.craigslist.org/pts/d/jefferson-city-chevy-step-side-bed-8ft/7593704487.html
  2. C

    Fuel hose

    Looking at replacing fuel hoses on my 84 K2500. Does anybody here have an outlet or source for thee premolded fuel hose? Thanks all.
  3. C

    dash pad preservation

    Hello all. Just curious what product you guys are using to preserve you dash pads with. Back in the '80's Armor All was the go to. But I'm hearing from folks that that did more harm than good. Thanks.
  4. C

    steering columns

    Hello, I tried to peruse the interchangable steering columns sticky but really wasn't making any headway with it. Does anybody know if a steering column from a GMT 400 3500 manual shift w/ tilt cross over to an 84 K2500? Thanks
  5. C

    knob removal

    Have a question (not sure it's in the right thread) I'm needing to change out a fan speed switch on my A/C, heater assembly but can't get the knobs to come off. Other than just pulling, with no result? Anybody here with a trick for that? Thanks
  6. C

    Intermittent wipers

    Hello, intermittent wipers on 84 K2500 are not working. New switch in column and known good junction switch under dash. Wipers only work on Hi and Low. Connections are clean and tight. Grounds clean and tight. Any suggestions? Thanks
  7. C

    Rebuilding an 84 steering column

    As the title says, I'm having trouble putting it back together and working. Getting frustrated. Does anyone have pics of the tumbler gear position that has the rod connected to it down to the ignition switch on lower column? Also having trouble with the ignition lock out button. Any pictures of...
  8. C

    Steering column

    Hello all, Have a question about my 84 steering column. I took it apart to replace the wiper/turn signal switch. Had to pull the ignition switch also. In putting it all back together I have a leftover spring that I don't remember removing. I'm thinking it has something to do with the ignition...
  9. C

    bed side panel removal

    Hello all. Searched the forums for this and all I found was how to remove the front bed panel. I'm trying to remove the driver side bed skin. I have all the spot welds drilled out and most of the panel loose but there is something holding it at the tail light pocket assembly. I don't see any...
  10. C

    G15 rear diff

    Howdy all, Just got a 1984 GMC K2500 8600 GVW.. RPO's are hard to read. Gives a G15 code for the rearend. It's a 14 bolt semi float.What ratio would this be? Thanks
  11. C

    Rebuilding an 84 steering column

    Hello, is it possible to change a manual drive steering column from an 83 to a manual steering column 84? Can the wiper/turn signal switch be switched out and put into the 83 column? Or, if not, can you take the automatic shifter section out of an automatic shift column. Just replace it with a...
  12. C

    Wheels

    Hello, what all year stock wheels will fit an 82 k20? Will Ford or Dodge wheels fit also? Seems like they used to back when. Thanks
  13. C

    Intermittent wipers

    Howdy, looking at picking up an '82 K20 and would be wanting to convert to intermittent wipers. Other than sourcing the switch are there any other provisions needed to accomplish this conversion? Thanks
  14. C

    A/C

    Question, how hard is it to put the factory A/C stuff in a non A/C truck? What all would have to be done?
  15. C

    Reverse polarity on battery

    Hello all. In an attempt to jump start an 83 square last evening the jumper cables were crossed on the 83. After discovery because of some sparks and smoke, we got them hooked up correctly. However upon trying to start the truck we only had headlights. No crank and no gauges. What all might have...
  16. C

    Delco radio

    Hello, does anyone know if there is a way to recalibrate the frequency indicator to match up with the station frequency on the stock Delco radios that came in our squares? Thanks. Any help would be appreciated.
  17. C

    AC Delco Radio

    Good morning. Would anybody on here know if the stock Delco radios in our squares can be calibrated to the correct frequency that corresponds to the numbers on the face? I listen to a station that's at frequency 95.7 but sits at about the 92 frequency.
  18. C

    Bouncy speedometer

    Good morning GMSB folks. I'm having an issue with my speedometer, 86k10, 700R4-208. I have replaced the speedo, the driven gear in T-case, pulled cable from sheath, lubed up cable and inside sheath and checked to make sure when routing cable there were no hard bends or kinks. Speedo still...
  19. C

    conduit?

    What is that tube called or described that the wires run through to protect them from exhaust manifolds from junction block to starter ? I've googled it under several different titles and keep coming up with wiring diagrams on how to wire the starter. Mine is missing and recently burned up an...
  20. C

    A/C compressor

    Hello, I have a question about an R4 compressor. GM shows they were used until '95 on trucks. My question is would an R4 compressor with the serpentine belt pulley work on our squares if I replaced the pulley with the V pulley? Thank you.
  21. C

    New but not

    :party36:Hello, not really new here as I've been lurking around off and on now for a couple years. Got some questions answered that way and also found a copious amount of information. :party36: But I guess I'm forum challenged because I cannot for the life of me find the spot where I can start a...
  22. C

    instrument lights

    Hello. I have an '86 k10. I recently replaced the cab with one from an 85 c10. I've had it for a year getting it ready but don't know how long cab sat before I got it. Having an issue with my instrument lights not coming on at all. I've checked all wires and fuses, cleaned grounds and PC seems...

Latest posts

Forum statistics

Threads
42,065
Posts
908,320
Members
33,542
Latest member
willyg
Top